In this paper a new mechanism for deep drawing was proposed to produce circular cup from thin plate without blank holder. In this technique the die assembly includes punch, die and die-punch. A 2D axisymmetric finite element model was built using DEFORM software. Effect of die geometry (half-cone angle) on maximum load, thickness distribution, strain distribution and effect of clearance ratio between punch and (die-punch) on the wrinkling of the cup were investigated. Three half-cone angles of die (15o, 30o and 45o) were used for forming sheet metal of brass (CuZn37) which had initial thickness of (1mm) at four clearance ratio (c/t) for die of 30o half-cone angle. Finite element model results showed good agreement with experimental results. Die of 30o half-cone angle with clearance ratio (c/t) of 0.9 gave the best product without wrinkling. The main advantage of this technique compared to the conventional deep drawing is that the circular cup can be carried out in single action press with limit drawing ratio (LDR) of 1.86 and blank diameter to blank thickness ratio (d/t) < 86.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.