Although some conventional manufacturing technologies are capable of producing functionally graded materials, only a few additive manufacturing processes are able to build functionally graded materials with complex distribution of material composition. To exploit this unique advantage, we have developed a new methodology capable of optimization of material distribution for three-dimensional parts for any given conditions. Representation of material distribution was done through a new technique by extending the nonuniform rational basis spline surfaces to four-dimensional space. Mori–Tanaka, Levin, and Tamura–Tomota–Ozawa models were employed for the estimation of effective material properties of functionally graded structures. Subroutines were developed in a commercial finite element software to enable the analysis of parts made from functionally graded material. A constrained particle swarm optimization method was selected and implemented to optimize the material composition distribution taking into account the additive manufacturing limitations. As a case study, the material distribution optimization of a functionally graded femur bone plate under thermomechanical loading was considered. The objective was to maximize the safety factor; i.e. the ratio of local yield strength of the functionally graded plate over the von Mises stress. The results showed significant improvement compared to nonoptimal part and demonstrated the efficacy of the proposed methodology.
Ceramic On‐Demand Extrusion (CODE) process has been recently proposed for additive manufacturing of strong ceramic components via extrusion. This paper focuses on fabricating 3 mol% yttria‐stabilized zirconia (3YSZ) components using CODE process, and enabling CODE to produce parts with support structures. A colloidal suspension of 3YSZ was developed and deposited through the main nozzle, and an organic feedstock was developed and deposited by means of another nozzle to fabricate supports. After printing and drying of raw parts, supports were removed by increasing the temperature and parts were then sintered to near theoretical (~99%) density. The maximum overhang angle that could be built with no support was also found out to be approximately 60 degrees. Three organic support materials, that is, polycaprolactone (PCL), silicone, and petrolatum were prepared and tested. PCL and petrolatum were identified as feasible support materials. Specimens were fabricated to validate the efficiency of the support materials and to evaluate CODE's capability for building parts with complex geometry. The microstructures of these parts were also analyzed via scanning electron microscopy.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.