Conducting polymer films are grown by mass-selected, hyperthermal thiophene ions coincident on a surface with a thermal beam of organic monomers of either alpha-terthiophene (3T) or p-terphenyl (3P) neutrals. Mass spectrometry and X-ray photoelectron spectroscopy previously verified polymerization of both 3T and 3P by 200 eV C(4)H(4)S(+) during surface polymerization by ion-assisted deposition (SPIAD). The electronic structure of these films are probed here by ultraviolet photoelectron spectroscopy (UPS) and polarized near-edge X-ray absorption fine structure spectroscopy (NEXAFS) and compared with similar spectra of evaporated films. The conducting polymer films formed by SPIAD display new valence band features resulting from a reduction in both their band gap and barrier to hole injection, which are calculated from the occupied and unoccupied valence band states measured by UPS and NEXAFS. These changes in film electronic structure result from an increase in the electron conjugation length and other changes in film structure induced by SPIAD.

Lead sulfide nanocrystals (PbS NCs) were codeposited into two organic films, titanyl phthalocyanine (TiOPc) and alpha-sexithiophene, using cluster beam deposition (CBD). NCs of average diameters of approximately 3-4 nm were evenly distributed in these organic films with average particle spacings of approximately 4 nm, as determined by transmission electron microscopy. The film composition and NC surface chemistry were monitored by X-ray photoelectron spectroscopy (XPS) and other methods. Pb:S stoichiometry in the NC/TiOPc film was determined by XPS to correspond to the PbS cubic rock salt structure. Soft-XPS using 200 eV energy photons determined the NC-organic surface chemistry by resolving the S 2p core level into four distinct components for sulfur. The soft-XPS results found that the PbS NC surface chemistry could be tuned by varying the H(2)S/Ar gas ratio within the CBD source.

Summary: Nanocomposite films were prepared by two methods in which lead sulfide (PbS) nanocrystals were contained in an organic matrix. One method used a wet chemical synthesis of the nanocrystals in the direct presence of a polymer, where the polymer controlled nanocrystal growth. The second method was gaseous deposition of nanocrystals into the organic phase. The two methods were similar in that the nanocrystals in the composites were free from surfactant capping layers that otherwise would add an interfacial region between the nanocrystal and the organic matrix. The gaseous deposition technique had several advantages over the wet chemical synthesis in that it allowed direct control over nanocrystal size and density, improved flexibility in the choice of organic phase, and was compatible with lithographic methods.

Conducting polymer films are grown by either mass-selected or non-mass-selected, hyperthermal thiophene ions coincident on a surface with a thermal beam of organic monomers of either alpha-terthiophene (3T) or p-terphenyl (3P) neutrals. Previous experiments verified polymerization of both 3T and 3P by 200 eV C(4)H(4)S(+) during surface polymerization by ion-assisted deposition (SPIAD). A wide variety of structures are observed by scanning electron microscopy to form in the SPIAD polythiophene and polyphenyl films. These structures include microscale islands, lamellar structures, fractal-like growth patterns, and nanoscale crystallites. Some of the deposited films diffract X-rays while others show electron micrographs of crystallites. The variation of these patterns with deposition conditions clearly indicate that ion-induced polymerization mediates film morphology through control of ion energy and ion/neutral ratio. Furthermore, these ion-assisted events mediate important thermal processes such as sublimation.