Decades of research focused on size and shape control of iron oxide nanoparticles have led to methods of synthesis that afford excellent control over physical size and shape, but comparatively poor control over magnetic properties. Popular synthesis methods based on thermal decomposition of organometallic precursors in the absence of oxygen have yielded particles with mixed iron oxide phases, crystal defects and poorer than expected magnetic properties, including the existence of a thick “magnetically dead layer” experimentally evidenced by a magnetic diameter significantly smaller than the physical diameter. Here, we show how single crystalline iron oxide nanoparticles with few defects and similar physical and magetic diameter distributions can be obtained by introducing molecular oxygen as one of the reactive species in the thermal decomposition synthesis. This is achieved without the need for any post-synthesis oxidation or thermal annealing. These results address a significant challenge in the synthesis of nanoparticles with predictable magnetic properties and pave way to advances in applications of magnetic nanoparticles.

No abstract

Abstract:Building on the application of cuprite (Cu 2 O) in solar energy technologies and reports of increased optical absorption caused by metal-to-semiconductor energy transfer, a confinement-based strategy was developed to fabricate high aspect ratio, crystalline Cu 2 O nanorods containing entrapped gold nanoparticles (Au nps). Cu 2 O was crystallized within the confines of track-etch membrane pores, where this physical, assembly-based method eliminates the necessity of specific chemical interactions to achieve a well-defined metalsemiconductor interface. With high-resolution scanning/transmission electron microscopy (S/TEM) and tomography, we demonstrate the encasement of the majority of Au nps by crystalline Cu 2 O and show that crystalline Au-Cu 2 O interfaces that are free of extended amorphous regions. Such nanocrystal heterostructures are good candidates for studying the transport physics of metal/semiconductor hybrids for optoelectronic applications.

No abstract

Barium titanate nanofibers were uniaxially aligned by electrospinning onto a rotating copper wire drum and alignment was maintained during calcination of the fibers. Two methods for maintaining alignment during calcination were tested, by either using carbon tape or a peeling off method to remove the aligned fibers from the mandrel followed by calcination. The carbon tape removal method led to the formation of shorter aligned nanowires while the peeling off method resulted in longer nanofibers. Additionally, the effects of calcination temperature and time on crystal structure were also examined. The degree of tetragonality in the barium titanate nanofibers increased at higher calcination temperatures and times. Piezoelectricity was confirmed in the nanofibers calcined using piezoeresponse force microscopy, yielding a d33 value of 15.5 pm/V. Using the methods presented here, large quantities of aligned piezoelectric barium titanate and other ceramic fibers or wires can be produced to fulfill their demand in novel microelectronics.

Photoluminescent silicon nanocrystals are very attractive for biomedical and electronic applications. Here a new process is presented to synthesize photoluminescent silicon nanocrystals with diameters smaller than 6 nm from a porous silicon template. These nanoparticles are formed using a pore-wall thinning approach, where the as-etched porous silicon layer is partially oxidized to silica, which is dissolved by a hydrofluoric acid solution, decreasing the pore-wall thickness. This decrease in pore-wall thickness leads to a corresponding decrease in the size of the nanocrystals that make up the pore walls, resulting in the formation of smaller nanoparticles during sonication of the porous silicon. Particle diameters were measured using dynamic light scattering, and these values were compared with the nanocrystallite size within the pore wall as determined from X-ray diffraction. Additionally, an increase in the quantum confinement effect is observed for these particles through an increase in the photoluminescence intensity of the nanoparticles compared with the as-etched nanoparticles, without the need for a further activation step by oxidation after synthesis.

No abstract

Abstract