No abstract

A simple, accurate, rapid and sensitive reversed-phase high-performance liquid chromatography (RP-HPLC) method was established for determination of a novel non-vitamin K antagonist oral anticoagulant drug, betrixaban, and its co-administered calcium-channel blocker drug, lercanidipine, in pharmaceutical formulations and biological fluids. The proposed HPLC method was the first chromatographic method applied to estimate this mixture in a short chromatographic run (<6 min), high resolution between betrixaban/lercanidipine (Rs = 7.12) and acceptable values of limit of detection (LOD), limit of quantification (LOQ) and percentage of relative standard deviation (%RSD). The chromatographic separation was performed on a cyano column using a mobile phase composed of acetonitrile:methanol:water (35:35:30, v/v/v) containing 0.2% orthophosphoric acid adjusted to pH 3.2 by triethylamine, programmed with a flow rate of 1 mL/min with UV detection at 240 nm. The proposed method showed linearity over the concentration ranges of (0.20–20.0 μg/mL) and (0.25–25.0 μg/mL) for betrixaban and lercanidipine, respectively. All validation parameters met the acceptance criteria according to ICH guidelines in terms of linearity, LOD, LOQ, accuracy, precision, robustness, specificity and system suitability. The method was applied to assay the studied analytes in their pharmaceutical formulations with high % recovery (98–102%) and low %RSD (<1.5). Furthermore, the proposed method was successfully applied for the determination of betrixaban in spiked human plasma.

No abstract

A highly sensitive, simple and rapid spectrofluorimetric method was developed for the determination of azelastine HCl (AZL) in either its pure state or pharmaceutical dosage form. The proposed method was based on measuring the native fluorescence of the studied drug in 0.2 M H SO at λ = 364 nm after excitation at λ = 275 nm. Different experimental parameters were studied and optimized carefully to obtain the highest fluorescence intensity. The proposed method showed a linear dependence of the fluorescence intensity on drug concentration over a concentration range of 10-250 ng/mL, with a limit of detection of 1.52 ng/mL and limit of quantitation of 4.61 ng/mL. Moreover, the method was successfully applied to pharmaceutical preparations, with percent recovery values (± SD) of 99.96 (± 0.4) and 100.1 (± 0.52) for nasal spray and eye drops, respectively. The results were in good agreement with those obtained by the comparison method, as revealed by Student's t-test and the variance ratio F-test. The method was extended to study the stability of AZL under stress conditions, where the drug was exposed to neutral, acidic, alkaline, oxidative and photolytic degradation according to International Conference on Harmonization (ICH) guidelines. Copyright © 2016 John Wiley & Sons, Ltd.

Background: The first highly sensitive, rapid and specific green microemulsion liquid chromatographic (MELC) method was established for the simultaneous estimation of fluticasone propionate (FLU) and azelastine HCl (AZL) in the presence of their pharmaceutical dosage form additives (phenylethyl alcohol (PEA) and benzalkonium chloride (BNZ)). Methods: The separation was performed on a C18 column using (o/w) microemulsion as a mobile phase which contains 0.2 M sodium dodecyl sulphate (SDS) as surfactant, 10% butanol as cosurfactant, 1% n-octanol as internal phase and 0.3% triethylamine (TEA) adjusted at pH 6 by 0.02 M phosphoric acid; with UV detection at 220 nm and programmed with flow rate of 1 mL/min. Results: The validation characteristics e.g. linearity, lower limit of quantification (LOQ), lower limit of detection (LOD), accuracy, precision, robustness and specificity were investigated. The proposed method showed linearity over the concentration range of (0.5-25 µg/mL) and (0.1-25 µg/mL) for FLU and AZL, respectively. Besides that, the method was adopted in a short chromatographic run with satisfactory resolution factors of (2.39, 3.78 and 6.74 between PEA/FLU, FLU/AZL and AZL/BNZ), respectively. The performed method was efficiently applied to pharmaceutical nasal spray with (mean recoveries ± SD) (99.80 ± 0.97) and (100.26 ± 0.96) for FLU and AZL, respectively. Conclusion: The suggested method was based on simultaneous determination of FLU and AZL in the presence of PEA and BNZ in pure form, laboratory synthetic mixture and its combined pharmaceutical dosage form using green MELC technique with UV detection. The proposed method appeared to be superior to the reported ones of being more sensitive and specific, as well as the separation was achieved with good performance in a relatively short analysis time (less than 7.5 min). Highly acceptable values of LOD and % RSD make this method superior to be used in quality control laboratories with of HPLC technique.

Green solvents such as microemulsion were used in the proposed method because they play a vital role in the analytical method's influence on the environment. A highly sensitive, specific, and validated stability-indicating eco-friendly green microemulsion liquid chromatography (MELC) method was developed for separation of the antihistaminic drug Azelastine HCl (AZL) from its degradation products with application to degradation kinetics. Chromatographic separation was operated on a C column with a microemulsion mobile phase, which consists of 0.1 M sodium dodecyl sulphate, 10% -propanol, 1%-octanol, and 0.3% triethylamine, by using 0.02 M phosphoric acid at pH 3.5 and irbesartan as internal standard. The eluted compounds were monitored at 210 nm with flow rate 1 mL/min at ambient temperature. A linear dependence of the peak area on drug concentration over the concentration range of 0.1 to 25 μg/mL was achieved with an LOD of 0.04 μg/mL and an LOQ of 0.10 μg/mL. Moreover, the proposed method was successfully applied for determination of AZL in eye drops and metered dose nasal inhaler as well as to study the kinetics of alkaline, acidic, neutral, oxidative, and photolytic degradation processes of AZL according to the International Council for Harmonization guidelines. The proposed method could be used as a harmless alternative for quality control analysis of the mentioned drug, without interference from dosage form additives or decomposition products. A highly sensitive stability-indicating eco-friendly green MELC method was developed for the separation of the antihistaminic drug AZL from its degradation products.

Three eco-friendly spectrophotometric methods were developed for determination of the novel anticoagulant drug, betrixaban (BTX). The first method (method A) was based on direct analysis of BTX at 229.4 nm on the zero-order spectrum using methanol as the optimum solvent. While the second method (method B) was based on measuring difference absorption value (ΔA) of BTX at 335 nm, which was obtained from pH-induced spectral difference (difference spectra of BTX in 0.1 M NaOH versus 0.1 M HCl). The third method (method C) was based on measurement of the first-derivative amplitudes of BTX and its co-administered Ca channel blocker lercanidipine (LER) at 304 and 229 nm for simultaneous assay of BTX and LER, respectively. All methods were linear over concentration ranges of 1.0–20.0 and 8.0–80.0 µg ml −1 for BTX in methods A and B, respectively, and of 1.0–20.0 and 1.0–25.0 µg ml −1 for BTX and LER, respectively, in method C. The three methods were fully validated and assessed for greenness by three metrics: analytical eco-scale, green analytical procedure index and Analytical GREEnness metrics. The results indicated the validity and greenness of the proposed methods. Moreover, the methods were applied to assay the studied analytes in their dosage forms with high percentage of recovery and low percentage of relative s.d. values.

No abstract