No abstract

Li–Ni–Mn spinels of nominal composition LiNi0.5Mn1.5O4, which are functional materials for electrodes in high‐voltage lithium batteries, are prepared by thermal decomposition of mixed nanocrystalline oxalates obtained by grinding hydrated salts and oxalic acid in the presence of polyethyleneglycol 400. Their structure, microstructure, and texture are established from combined X‐ray photoelectron spectroscopy (XPS), X‐ray diffraction, transmission electron microscopy (TEM), IR spectroscopy, and N2 absorption measurements. The polymer tailors the shape of particles, which adopt a nanorodlike morphology at low temperatures (400 °C). In fact, the nanorods consist of highly distorted oriented nanocrystals connected by a polymer‐based film as inferred from IR and XPS spectra. The electrochemical properties of spinels in this peculiar form are quite poor, mainly as a result of the high microstrain content of their nanocrystals. Raising the temperature up to 800 °C partially destroys the nanorods, which become highly crystalline nanoparticles approximately 80 nm in size. At this temperature, the polymer facilitates crystal growth; this leads to highly crystalline polyhedral nanoparticles as revealed from TEM images and microstrain data. Following functionalization as a cathode in lithium cells, this material exhibits a very good rate capability, coulombic efficiency, and capacity retention even upon cycling at voltages as high as 5 V. Moreover, it withstands fast‐charge–slow‐discharge processes, which is an important cycle‐life‐related property for commercial batteries.

Graphene nanosheets (GNS) were prepared from graphitic oxide (GO) in two different ways: (a) thermal exfoliation at different temperatures; and (b) wet chemistry, using aqueous N(2)H(4) and KBH(4) as reducing agents. Irrespective of the synthetic method used, the materials exhibited a high irreversible capacity and strong polarization in their charge curves, when used in a Li-ion battery. The GNS synthesized with N(2)H(4) exhibited the best performance. Thus, at 149 mA g(-1) the average specific capacity delivered was ca. 600 mA h g(-1) after 100 cycles. On the other hand, the worst performance, irrespective of rate, was that of GNS synthesized with KBH(4) and the thermal GNS obtained at 800 °C. The physical and chemical analyses allowed various parameters to be derived for correlation with the electrochemical properties. Unfortunately, no clear-cut correlation was apparent. A comparison with reported data revealed that no correlation appears to exist with physical and chemical properties that allows a simple strategy for tailoring an effective graphene anode to be designed.

Graphene-based materials are highly interesting in virtue of their excellent chemical, physical and mechanical properties that make them extremely useful as privileged materials in different industrial applications. Sonochemical methods allow the production of low-defect graphene materials, which are preferred for certain uses. Graphene nanosheets (GNS) have been prepared by exfoliation of a commercial micrographite (MG) using an ultrasound probe. Both materials were characterized by common techniques such as X-ray diffraction (XRD), Transmission Electronic Microscopy (TEM), Raman spectroscopy and X-ray photoelectron spectroscopy (XPS). All of them revealed the formation of exfoliated graphene nanosheets with similar surface characteristics to the pristine graphite but with a decreased crystallite size and number of layers. An exhaustive study of the particle size distribution was carried out by different analytical techniques such as dynamic light scattering (DLS), nanoparticle tracking analysis (NTA) and asymmetric flow field flow fractionation (AF4). The results provided by these techniques have been compared. NTA and AF4 gave higher resolution than DLS. AF4 has shown to be a precise analytical technique for the separation of GNS of different sizes.

No abstract