No abstract

In this study, morphological and rheological properties of cycloolefin copolymer (COC)/graphite composites prepared in a twin screw extruder by using various amounts of graphite (G) and expanded graphite (EG) were investigated in detail. Rheological behaviors of the samples were measured in a dynamic oscillatory rheometer in the melt state. Rheology data were analyzed in different ways in order to quantify the microstructural features which indicate the solid-state physical properties of the composite materials. In the linear viscoelastic region, increasing of storage modulus (G 0 ) with the filler amount and the van Gurp-Palmen plots were used to determine the percolation threshold which is the critical filler amount for the physical network formation by the G sheets. Percolation threshold values were found to be about 21.5 phr and 3.8 phr for the G-and EG-loaded samples, respectively. Microstructures of the samples which include quite higher amount of filler than the percolation were observed in a scanning electron microscopy. It was found that the sheets of pristine G maintained their original stack form while the EG was successfully dispersed in the COC phase and formed three dimensional house-ofcard structures without a compatibilizer. POLYM. ENG.

No abstract

No abstract

No abstract

No abstract

No abstract

In this study, isotactic poly(propylene) (PP)/poly(oxymethylene) (POM) blend films, including of POM as minor phase in the range of 10–30 wt%, are prepared in a twin screw extruder equipped with a slit‐die and cast film haul‐off unit. It is found that the blend films show characteristic immiscible matrix‐droplet morphology. Short‐term uniaxial tensile creep behaviors of films imply that the introducing of POM significantly improves the elastic modulus and decreases the total creep strain of PP/POM blends. Creep tests are also performed at various temperatures and long‐term deformations of samples are predicted by applying of time‐temperature superposition principle and the Findley model. It is found that the presence of POM domains into PP matrix enhances the creep resistance of PP especially at high temperatures. It is concluded that the PP‐rich PP/POM blend films show much lower short and long‐term creep strains compared to PP.