Gluten-free (GF) pasta samples containing rice flour replaced with 0, 5, 10, 15 g/100 g (w/w) of a resistant starch ingredient from annealed sorghum starch (annRS) were formulated. The highest total dietary fiber and RS contents (p < 0.05) were measured in uncooked pasta with 15 g/100 g of annRS addition (15-annRS). After cooking, the 15-annRS pasta was characterized by an RS content of 5.8 g/100 g dry matter, confirming the thermal resistance of annRS. The use of annRS positively influenced the optimal cooking time, the cooking loss, the firmness, and the stickiness of the cooked samples, with not remarkably change in color after cooking. The starch hydrolysis index values decreased as the level of annRS increased. Despite a significant decrease in the overall sensory with increasing levels of annRS, all samples were characterized by a value > 5, which is considered the limit of acceptability. The use of annRS in GF pasta up to 15 g/100 g can contribute to creating GF products with high total dietary fiber content, slowly digestible starch properties, and without drastically compromising the sensory attributes.

This study determined the physicochemical properties (apparent viscosity (ηapp), turbidity (A550nm), particle size and molecular mass distribution) of hydrolysates generated from whey protein concentrate (WPC), milk protein concentrate (MPC) and sodium caseinate (NaCN), following incubation with Debitrase HYW20™ and Prolyve™ at 50 °C, pH 7.0 for 1 and 4 h, before and after heat inactivation (80 °C for 10 min). The degree of hydrolysis (DH) increased with incubation time, giving values of 6.56%, 8.17% and 9.48%, following 1 h hydrolysis of WPC, MPC and NaCN with Debitrase HYW20™, and 12.04%, 15.74% and 17.78%, respectively, following 4 h incubation. These DHs were significantly higher compared to those obtained following 4 h incubation with Prolyve™. Hydrolysis with Debitrase HYW20™ gave >40% of peptides with molecular masses < 1 kDa for all substrates, which was higher than the value obtained following hydrolysis with Prolyve™. The effect of hydrolysis on the physicochemical properties was substrate dependent, since ηapp decreased in WPC and NaCN hydrolysates, particle size decreased for all the substrates, with aggregate formation for MPC, and turbidity decreased in WPC and MPC hydrolysates, while it increased in NaCN hydrolysates. The physical properties of the hydrolysates were influenced by the enzyme thermal inactivation step in a DH-dependent manner, with no significant effect on turbidity and viscosity for hydrolysates at higher DHs.

The antioxidant activity of baked foods is of utmost interest when envisioning enhancing their health benefits. Incorporating functional ingredients is challenging since their bioactivity naturally declines during baking. In this study, 3D food printing and design of experiments are employed to clarify how the antioxidant activity of cookies enriched with encapsulated polyphenols can be maximized. A synergistic effect between encapsulation, time, temperature, number of layers, and infill of the printed cookies was observed on the moisture and antioxidant activity. Four-layer cookies with 30% infill provided the highest bioactivity and phenolic content if baked for 10 min and at 180 • C. The bioacitivity and total phenolic content improved by 115% and 173%, respectively, comparing to free extract cookies.Moreover, the proper combination of the design and baking variables allowed to vary the bioactivity of cooked cookies (moisture 3-5%) between 300 and 700 μmolTR/gdry.The additive manufacture of foods with interconnected pores could accelerate baking and browning, or reduce thermal degradation. This represents a potential approach to enhance the functional and healthy properties of cookies or other thermal treated bioactive food products.

In this work, extra-virgin olive oil (EVO)- and sunflower oil (SFO)-based oleogels were structured using rice bran wax (RBW) at 10% by weight (w/w). Bamboo fiber milled with 40 (BF40), 90 (BF90) and 150 (BF150) µm of average size was added as a structuring agent. The effect of fiber addition and cooling temperature (0, 4, and 25 °C) on thermal and structural parameters of achieved gels was assessed by rheological (both in rotational and oscillatory mode), texture, and differential scanning calorimetry tests. Oleogelation modified the rheological behavior of EVO and SFO, thus shifting from a Newtonian trend typical of oils to a pseudoplastic non-Newtonian behavior in gels. Moreover, oleogels behaved as solid-like systems with G′ > G″, regardless of the applied condition. All samples exhibit a thermal-reversible behavior, even though the presence of hysteresis suggests a partial reduction in structural properties under stress. Decreasing in cooling temperature negatively contributed to network formation, despite being partially recovered by low-granulometry fiber addition. The latter dramatically improved either textural, rheological, or stability parameters of gels, as compared with only edible oil-based systems. Finally, wax/gel compatibility affected the crystallization enthalpy and final product stability (gel strength) due to different gelator–gelator and gelator–solvent interactions.

Different commercial fibres from bamboo (BAM), cocoa (COC), psyllium (PSY), chokeberry (ARO) and citrus (CIT) were characterized for technological (oil- and water-holding capacity, solubility and bulk density) and physical (moisture, colour and particle size) features and added to a cookie recipe. The doughs were prepared using sunflower oil and white wheat flour was substituted with 5% (w/w) of the selected fibre ingredient. The attributes of the resulting doughs (colour, pH, water activity and rheological tests) and cookies (colour, water activity, moisture content, texture analysis and spread ratio) were compared to control doughs and to cookies made with refined flour and whole flour formulation. The selected fibres consistently impacted dough rheology and, consequently on, the spread ratio and the texture of the cookies. While the viscoelastic behaviour of the control dough made with refined flour was maintained in all sample doughs, adding fibre decreased loss factor (tan δ), except for ARO-added dough. Substitution of wheat flour with fibre decreased the spread ratio except for the PSY addition. The lowest spread ratio values were observed for CIT-added cookie, which were similar to whole flour cookies. The addition of phenolic-rich fibres positively affected the in vitro antioxidant activity of the final products.

In oenology, fungoid chitosan (CH) can be used as an adjuvant for microbial control, haziness prevention, metal chelation, and ochratoxin removal. In acidic media (such as wine), CH can ionise and interact with charged compounds, giving rise to a series of adsorption and/or removal phenomena, some of which potentially impairing the overall quality of wines. In this context, it is worth noting that the interaction between CH and acidic components of wines has been poorly studied so far, and detailed information on this subject is still lacking. To study those interactions, different doses of chitosan (0.5; 1.0; 2.0 g/L) were dispersed in hydro-alcoholic solution (HS), synthetic wine solution (SW), and white wine (W). Results demonstrated that the remotion of tartaric acid and the change of pH were strongly affected by the matrix and dosage. In W and SW, chitosan was found to adsorb tartaric acid up to about 200 mg/g and 350 mg/g CH, respectively. Accordingly, pH values increased; however, the magnitude depended on the matrix as a consequence of different buffer capacities. Interestingly, even in the absence of tartaric acid (e.g. in HS samples) CH addition caused a pH increase (up to 1.2 units for 2 g/L CH addition) which demonstrated that pH variations may not only depend on the amount of organic acids adsorbed. The chitosan dispersed in W showed the highest average diameter D [3,2] (127.96 μm) compared to the ones dispersed in SW (120.81 μm) and in HS (116.26 μm), probably due to the presence of organic acids on the polymer surface. The minor removal of tartaric acid in W compared to SW could probably depend on the competitive adsorption onto chitosan of other families of compounds present in wine such as polyphenols. The data suggested that chitosan addition could affect the pH and organic acid concentration of all matrices, depending on the doses and composition of the solutions.