No abstract

No abstract

No abstract

No abstract

This paper presents an experimental investigation on a copper miniature loop heat pipe (mLHP) with a flat disk shaped evaporator, 30 mm in diameter and 10-mm thick, designed for thermal control of computer microprocessors. Tests were conducted with water as the heat transfer fluid. The device was capable of transferring a heat load of 70 W through a distance up to 150 mm using 2-mm diameter transport lines. For a range of power applied to the evaporator, the system demonstrated very reliable startup and was able to achieve steady state without any symptoms of wick dry-out. Unlike cylindrical evaporators, flat evaporators are easy to attach to the heat source without need of any cylinder-to-plane reducer material at the interface and thus offer very low thermal resistance to the heat acquisition process. In the horizontal configuration, under air cooling, the minimum value for the mLHP thermal resistance is 0.17 C/W with the corresponding evaporator thermal resistance of 0.06 C/W. It is concluded from the outcomes of the current study that a mLHP with flat evaporator geometry can be effectively used for the thermal control of electronic equipment including notebooks with limited space and high heat flux chipsets. The results also confirm the superior heat transfer characteristics of the copper-water configuration in mLHPs.Index Terms-CPU cooling, flat evaporator, miniature loop heat pipe (mLHP), thermal control.

No abstract

Theoretical investigation has shown a simple reaction water turbine would perform better when it spins faster. And for the simple reaction turbine water turbine to spin faster under constant water head, its diameter should be smaller. This paper reports on a performance analysis based on the experimental data collected from different performance tests carried on two simple reaction water turbine prototypes. Two new designs of simple reaction water turbines and their manufacturing methods are reported. The two turbines under investigation have different rotor diameters Φ 0.243 m and Φ 0.122 m. In case of the simple reaction water turbine the water enters into the turbine axially and exits tangentially through nozzles located on the outer periphery of the turbine. Further this paper will discuss the performance characteristics of stationary turbine i.e. zero power produced and performance characteristics of turbine producing power. It was found that rotor diameter affects the maximum rotational speed of the simple reaction turbine for constant supply head. It was also found that faster the turbine spins its performance improves. The two turbines were tested between supply head range of 1 m to 4 m

No abstract