No abstract

The widespread adoption of Ethernet L2VPN services and the advent of new applications for the technology (e.g., data center interconnect) have culminated in a new set of requirements that are not readily addressable by the current Virtual Private LAN Service (VPLS) solution. In particular, multihoming with all-active forwarding is not supported, and there's no existing solution to leverage Multipoint-to-Multipoint (MP2MP) Label Switched Paths (LSPs) for optimizing the delivery of multi-destination frames. Furthermore, the provisioning of VPLS, even in the context of BGP-based autodiscovery, requires network operators to specify various network parameters on top of the access configuration. This document specifies the requirements for an Ethernet VPN (EVPN) solution, which addresses the above issues.

Status of This Memo This document is not an Internet Standards Track specification; it is published for informational purposes. This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Not all documents approved by the IESG are a candidate for any level of Internet Standard; see Section 2 of RFC 5741. Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc7080.

No abstract

This document describes how Ethernet VPN (EVPN) can be used to support the Virtual Private Wire Service (VPWS) in MPLS/IP networks.

No abstract

This document provides framework and requirements for Layer 2 Virtual Private Network (L2VPN) Operations, Administration, and Maintenance (OAM). The OAM framework is intended to provide OAM layering across L2VPN services, pseudowires (PWs), and Packet Switched Network (PSN) tunnels. This document is intended to identify OAM requirements for L2VPN services, i.e., Virtual Private LAN Service (VPLS), Virtual Private Wire Service (VPWS), and IP-only LAN Service (IPLS). Furthermore, if L2VPN service OAM requirements impose specific requirements on PW OAM and/or PSN OAM, those specific PW and/or PSN OAM requirements are also identified.

Extensions to the Virtual Private LAN Service (VPLS) Provider Edge (PE) Model for Provider Backbone Bridging Abstract The IEEE 802.1 Provider Backbone Bridges (PBBs) specification defines an architecture and bridge protocols for interconnection of multiple Provider Bridged Networks (PBNs). Provider backbone bridging was defined by IEEE as a connectionless technology based on multipoint VLAN tunnels. PBB can be used to attain better scalability than Provider Bridges (PBs) in terms of the number of customer Media Access Control addresses and the number of service instances that can be supported.The Virtual Private LAN Service (VPLS) provides a framework for extending Ethernet LAN services, using MPLS tunneling capabilities, through a routed MPLS backbone without running the Rapid Spanning Tree Protocol (RSTP) or the Multiple Spanning Tree Protocol (MSTP) across the backbone. As a result, VPLS has been deployed on a large scale in service provider networks.This document discusses extensions to the VPLS Provider Edge (PE) model required to incorporate desirable PBB components while maintaining the service provider fit of the initial model.