Objectives The aim of this study was to investigate microhardness and compressive strength of composite resin (Tetric-Ceram, Ivoclar Vivadent), compomer (Compoglass, Ivoclar, Vivadent), and resin modified glass ionomer cement (Fuji II LC, GC Corp) polymerized using halogen light (Optilux 501, Demetron, Kerr) and LED (Bluephase C5, Ivoclar Vivadent) for different curing times. Methods Samples were placed in disc shaped plastic molds with uniform size of 5 mm diameter and 2 mm in thickness for surface microhardness test and placed in a diameter of 4 mm and a length of 2 mm teflon cylinders for compressive strength test. For each subgroup, 20 samples for microhardness (n=180) and 5 samples for compressive strength were prepared (n=45). In group 1, samples were polymerized using halogen light source for 40 seconds; in group 2 and 3 samples were polymerized using LED light source for 20 seconds and 40 seconds respectively. All data were analyzed by two way analysis of ANOVA and Tukey’s post-hoc tests. Results Same exposure time of 40 seconds with a low intensity LED was found similar or more efficient than a high intensity halogen light unit (P>.05), however application of LED for 20 seconds was found less efficient than 40 seconds curing time (P=.03). Conclusions It is important to increase the light curing time and use appropriate light curing devices to polymerize resin composite in deep cavities to maximize the hardness and compressive strength of restorative materials.

The aim of the study was to establish the colonization of Streptococcus mutans and to determine the possibility of intra-familial transmission in a group of Turkish children and their parents. A total of 56 children participated in the study together with their parents (20 fathers and 49 mothers). Saliva samples were collected from the individuals and cultivated on S. mutans selective TYCSB agar. The typical isolates of S. mutans were identified by using classical microbiological methods, as well as molecular typing of S. mutans clones which was performed by using AP PCR with OPA5 primer for the detection of transmission. The vertical transmission of salivary S. mutans was detected among 14 mother-father-child, 35 mother-child (one twins) and 6 father-child combinations. The homologies of strain types were recorded as 24% and 16.6% for mother-child and father-child combinations, respectively. A significant positive correlation (p<0.001) was found between the infected children and their parents with high S. mutans counts.

No abstract

Objectives:To measure the release of TEGDMA and BisGMA from two commercially available composite resins; Filtek Z 250 (3M ESPE, Germany), Leaddent (Leaddent, Germany) and two fissure sealants; Helioseal F (3M ESPE, Germany) Enamel Loc (Premiere Rev, USA) over 1, 3 and 7 days after polymerization with standard quartz-tungsten halogen Coltolux II (QHL) (Coltene Switzerland) and a standard blue light emitting diode Elipar Freelight 2 (3M ESPE, Germany).Methods:9 samples of each material were placed in disc shaped specimens in 1 mm of thickness and 10 mm in diameter (n=36). Each material was polymerized using LED for 20 s (n=12), 40 s (n=12) and halogen for 40 s (n=12), respectively. High Performance Liquid Chromatography (HPLC) was used to measure the amount of monomers released over 1, 3 and 7 days. Data was analyzed using one way ANOVA and Bonferroni test for multiple comparisons with a significance level of .05.Results:LED 20 sec group showed the highest release of monomers at 1, 3 and 7 days in sealant groups. Halogen 40 sec group resulted highest release of monomers for Leaddent at all time intervals (P<.05)Conclusions:Efficiency of the curing unit and applying the recommended curing time of the light activated resin based dental materials is very important to protect the patient from potential hazards of residual monomers.

The mothers or the fathers could be the source for the transmission of S. mutans to their children.

The term mesiodens refers to a supernumerary tooth located between the maxillary central incisors. The aim of the study was to investigate the characteristics of mesiodens among children in Turkey.The study population involved 24 children who attended the Department of Pediatric Dentistry, Ege University for dental problems. The characteristics of mesiodens were obtained from clinical and radiographic examinations. Results showed that twenty-four patients had thirty-four mesiodens for an average of 1.42 mesiodens per person. Males were affected approximately 3 times more frequently in comparison with females. Forty-two percent of the patients had bilateral mesiodens.All of the mesiodens were conical in shape and 91 % were in the downward position. The age and sex distribution, location, direction, eruption of mesiodens and effects on permanent maxillary incisors were also presented in this study. It could be concluded that, delayed, ectopic or asymmetric eruption of the central incisors should alert the clinician to the possibility of a mesiodens.

No abstract

No abstract