No abstract

It has previously been shown that polyethylene (PE) with a bimodal molar mass distribution has a high fracture toughness. Our approach has been to use coarse-grained (CG) molecular dynamics (MD) simulations to investigate the effects of including short-chain branches in the high molar mass fraction of bimodal PE on topological features and mechanical behavior of the material. The CG potentials were derived, validated, and utilized to simulate melt equilibration, cooling, crystallization, and mechanical deformation. Crystallinity, tie chain, and entanglement concentrations were continuously monitored. During crystallization, the branched bimodal systems disentangled to a lesser degree and ended up with a higher entanglement density than the linear bimodal systems simulated in our previous study. The increase in entanglement concentration was proportional to the content of the branched high molar mass fraction. A significantly higher tie chain concentration was obtained in the short-chain branched bimodal systems than in the linear systems. The increase in the number of ties was more pronounced than the increase in the number of entanglements. The tie chain concentration was not proportional to the content of the high molar mass fraction. Despite a lower crystal thickness and content, the elastic modulus and yield stress values were higher in the branched bimodal systems. A more pronounced strain hardening region was observed in the branched systems. It was suggested that the higher tie chain and entanglement concentration prior to the deformation, the more extensive disentanglement during the deformation, and the disappearance of formed voids prior to failure point were the reasons for the observed higher toughness of the short-chain branched bimodal PE compared with that of the linear bimodal systems. The toughest system, which contained respectively 25 and 75 wt % low molar mass and branched high molar mass fractions, had the highest tie chain concentration and the second highest entanglement concentration of the simulated systems.

No abstract

In order to increase our fundamental knowledge about high-voltage cable insulation materials, realistic polyethylene (PE) structures, generated with a novel molecular modeling strategy, have been analyzed using first principle electronic structure simulations. The PE structures were constructed by first generating atomistic PE configurations with an off-lattice Monte Carlo method and then equilibrating the structures at the desired temperature and pressure using molecular dynamics simulations. Semicrystalline, fully crystalline and fully amorphous PE, in some cases including crosslinks and short-chain branches, were analyzed. The modeled PE had a structure in agreement with established experimental data. Linear-scaling density functional theory (LS-DFT) was used to examine the electronic structure (e.g., spatial distribution of molecular orbitals, bandgaps and mobility edges) on all the materials, whereas conventional DFT was used to validate the LS-DFT results on small systems. When hybrid functionals were used, the simulated bandgaps were close to the experimental values. The localization of valence and conduction band states was demonstrated. The localized states in the conduction band were primarily found in the free volume (result of gauche conformations) present in the amorphous regions. For branched and crosslinked structures, the localized electronic states closest to the valence band edge were positioned at branches and crosslinks, respectively. At 0 K, the activation energy for transport was lower for holes than for electrons. However, at room temperature, the effective activation energy was very low (∼0.1 eV) for both holes and electrons, which indicates that the mobility will be relatively high even below the mobility edges and suggests that charge carriers can be hot carriers above the mobility edges in the presence of a high electrical field.

No abstract