The problem of environmental pollution and depletion of fossil fuel can be reduced in automotives by using an alternative bio-fuel and improve the ignition process in engine. Both solutions need to use the fuel preheating technique. This work presents the idea of fuel preheating by using exhaust impingement on the fuel tank. Heat transfer between twin pulsating hot air jets and flat copper target was investigated as an application for preheating of automotive fuel to improve ignition process in the engine. The nozzle of 20 mm was used to produce air jet of Reynolds number, Re ≃ 5500 and a temperature of 54°C. The impinged target was imposed to still air surrounding at temperature of 24°C. Pulsating frequencies of 10-50 Hz were applied on air jets by using twin pulsating jet mechanism. The effect of pulsation frequency on heat transfer was measured using IR camera and heat flux-temperature micro foil sensor. The results obtained by both of these methods showed well agreement. Also, the results revealed significant influence of flow rate difference between steady and pulsating jet cases. In addition, the highest Nusselt number, Nu ≃ 7.2, was obtained at pulsation frequency of 20 Hz.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.