No abstract

We report a study on the mechanical properties of lamellae-forming glassy−semicrystalline block copolymers composed of poly(cyclohexylethylene) (C) and polyethylene (E). Tensile properties of polydomain CEC, ECEC, CECEC, and ECECE block copolymers, and blends of these materials, reveal a critical dependence on the connectivity of the semicrystalline E blocks. A molecular parameter directly related to the fraction of bridging E blocks is identified, which captures the fracture behavior of C/E block copolymers over a range of chain architectures. Tensile testing and small-angle X-ray scattering (SAXS) experiments on aligned block copolymers reveal the role of bridging in the glassy C block and further elucidate the mechanisms that govern the deformation of microphase-separated lamellar domains and macroscopic fracture in glassy−semicrystalline block copolymers.

High Viscosity Friction Reducers (HVFRs) are often employed in hydraulic fracturing fluids to increase the proppant carrying capacity of slickwater fluids. However, it has been widely reported that the performance of HVFR fluids drops precipitously with even small amounts of salt. This study explores and reports the use of surfactants to alleviate the loss of performance of HVFR fluids due to salinity in the mix water. Fracturing fluids were prepared in the laboratory by mixing the HVFR at concentrations between 2 and 8 gal/1,000 gal with and without surfactant formulations. The viscosities of the fluids were measured on a TA Instruments DHR-3 rheometer using a concentric cylinder geometry. Both anionic and cationic HVFRs were tested with various surfactants. As expected, we observed that HVFR fluids display dramatic loss of viscosity with the addition of as little as 1% salt to the mix water. However, certain surfactant formulations were found to provide a significant boost in viscosity of HVFR fluids in brines over a wide range of shear rates. Increases in viscosity by a factor of as much as 10 times were observed, particularly at low shear rates. The ability of the surfactant formulations to enhance fluid viscosity was observed in both monovalent and divalent model brines, as well as brines that mimicked field produced water compositions. In addition, measurements were also performed in a slot flow device to determine if the results from the rheometer translated to proppant transport characteristics of the fluids. The slot flow results were found to correlate well with fluid viscosity measurements. The fluids containing the surfactant formulation transported nearly 4 times as much proppant as fluids not containing surfactant through a 2.5 ft. long rectangular slot of 0.5 in. thickness at a proppant concentration of 2 lb/gal. An obvious benefit of the approach proposed in this study is that it can enable the use of HVFR fluids in recycled and produced waters, providing both cost and sustainability benefits. Secondly, these surfactant formulations can reduce the amount of HVFR required to obtain a certain target viscosity in brine, thereby reducing the likelihood and potential severity of formation damage from HVFR residue.

No abstract

No abstract