Because
of the growing world energy demand, biofuels obtained from
the hydrotreatment of vegetable oils represent a renewable alternative
to replace fossil fuels. The development of mathematical models is
an accurate tool to design and simulate the performance of the reactor
to predict product yields during the hydrotreatment of these oils.
Better understanding of the different phenomena occurring during the
hydrotreatment of vegetable oils and parameters influencing on this
process by means of kinetic and reactor modeling is required. This
was the motivation to develop an exhaustive review on different aspects
of reaction kinetics, catalytic deactivation, and reactor modeling.
Kinetics of model compounds and real feedstocks (oils) used to produce
biofuels are analyzed and different assumptions for developing of
reaction rate equations are discussed. It has been recognized that
catalyst deactivation and reactor modeling must be deeply studied
and supported with experimental data. There are few reported models
that consider the mass transfer and temperature inside the catalytic
particle. However, there are no models that consider the phase distribution
and dispersion in the transient state, nor correlations
to calculate the solubility of hydrogen in this type of system.
During steam injection processes, oil-soluble catalysts
have demonstrated
high efficiency by improving the flow properties of heavy crude oil
into the reservoir. In order to gain a deeper understanding of the
effect of this catalyst type and its reaction mechanism, further studies
based on complex kinetic models are required. The catalytic effect
of copper oleate on aquathermolysis of heavy crude oil was studied
using experimental data obtained with a water/oil ratio of 3:7, a
temperature range of 250 to 300 °C, and up to 72 h of reaction
time. A kinetic model was developed to predict the yield of the SARA
fractions and gases. The calculated kinetic parameters presented a
proper fit concerning experimental data with average absolute error
values lower than 4%. Results showed that copper oleate reduces the
polyaddition reactions of heavy fractions, favoring the production
of lighter compounds. A set of in-series and parallel reactions indicate
that the reaction gas and aromatic compounds are mainly produced from
the asphaltene fraction, where aromatic fractions subsequently generate
saturates hydrocarbons.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.