Background: Current response criteria in rheumatoid arthritis (RA) usually assess only three patient-reported outcomes (PROs): pain, functional disability and patient global assessment. Other important PROs such as fatigue are not included. Objective: To elaborate a patient-derived composite response index for use in clinical trials in RA, the RA Impact of Disease (RAID) score. Methods: Ten patients identified 17 domains or areas of health relevant for inclusion in the score, then 96 patients (10 per country in 10 European countries) ranked these domains in order of decreasing importance. The seven most important domains were selected. Instruments were chosen for each domain after extensive literature research of psychometric properties and expert opinion. The relative weight of each of the domains was obtained from 505 patients who were asked to ''distribute 100 points'' among the seven domains. The average ranks of importance of these domains were then computed.

Initial RBH of less than 4 mm influenced the success rates of implants inserted in combination with sinus floor elevation using osteotomes.

A provisionalization sequence is essential for obtaining a predictable final prosthetic outcome. An assessment of the mechanical behavior of interim prosthetic materials could orient clinicians towards selecting an appropriate material for each clinical case. The aim of this study was to comparatively evaluate the mechanical behavior—with compressive and three-point flexural tests—of certain 3D-printed and conventional resins used to obtain interim fixed dental prostheses. Four interim resin materials were investigated: two 3D-printed resins and two conventional resins (an auto-polymerized resin and a pressure/heat-cured acrylic resin). Cylindrically shaped samples (25 × 25 mm/diameter × height) were obtained for the compression tests and bar-shaped samples (80 × 20 × 5 mm/length × width × thickness) were produced for the flexural tests, observing the producers’ recommendations. The resulting 40 resin samples were subjected to mechanical tests using a universal testing machine. Additionally, a fractographic analysis of failed samples in bending was performed. The results showed that the additive manufactured samples exhibited higher elastic moduli (2.4 ± 0.02 GPa and 2.6 ± 0.18 GPa) than the conventional samples (1.3 ± 0.19 GPa and 1.3 ± 0.38 GPa), as well as a higher average bending strength (141 ± 17 MPa and 143 ± 15 MPa) when compared to the conventional samples (88 ± 10 MPa and 76 ± 7 MPa); the results also suggested that the materials were more homogenous when produced via additive manufacturing.

No abstract

This in vitro study analyses the biochemical interaction between saliva and three types of dental composite resins (a direct resin, an indirect resin and a dual-cure resin used for cementation of indirect dental restorations). The resin samples were obtained following a specific protocol and in line with the producers� recommendations; the resin samples were incubated with saliva samples collected from 19 healthy volunteers. The obtained results showed that the tested composite resins did not produce significant changes in oxidative stress parameters that were analysed (albumin, uric acid, GGT / gamma glutamyl transferase, OXSR-1 / oxidative stress responsive kinase 1) and do not influence the inflammatory salivary status reflected by the levels of IL-6 - an inflammatory marker.