Photorhabdus luminescens is a pathogenic bacterium that produces many toxic proteins. The mono-ADP-ribosyltransferases (mARTs) are an enzyme class produced by numerous pathogenic bacteria and participate in disease in plants and animals, including humans. Herein we report a novel mART from P. luminescens called Photox. This 46-kDa toxin shows high homology to other actin-targeting mARTs in hallmark catalytic regions and a similar core catalytic fold. Furthermore, Photox shows in vivo cytotoxic activity against yeast, with protection occurring when catalytic residues are substituted with alanine. In vitro, enzymatic activity (k cat , 1680 ؎ 75 min ؊1 ) is higher than that of the related iota toxin, and diminishes by nearly 14,000-fold following substitution of the catalytic Glu (E355A). This toxin specifically ADP-ribosylates monomeric ␣-skeletal actin and nonmuscle ␤-and ␥-actin at Arg 177 , inhibiting regular polymerization of actin filaments. These results indicate that Photox is indeed an ADP-ribosyltransferase, making it the newest member of the actin-targeting mART family.

Determining the molecular mechanisms that lead to the development of heart failure will help us gain better insight into the most costly health problem in the Western world. To understand the roles that the actin protein plays in the development of heart failure, we have taken a systematic approach toward characterizing human cardiac actin mutants that have been associated with either hypertrophic or dilated cardiomyopathy. Seven known cardiac actin mutants were expressed in a baculovirus system, and their intrinsic properties were studied. In general, the changes to the properties of the actin proteins themselves were subtle. The R312H variant exhibited reduced stability, with a T m of 53.6°C compared to 56.8°C for WT actin, accompanied with increased polymerization critical concentration and Pi release rate, and a marked increase in nucleotide release rates. Substitution of methionine for leucine at amino acid 305 showed no impact on the stability, nucleotide release rates, or DNase-I inhibition ability of the actin monomer; however, during polymerization, a 2-fold increase in Pi release was observed. Increases to both the T m and DNase-I inhibition activity suggested interactions between E99K actin molecules under monomer-promoting conditions. Y166C actin had a higher critical concentration resulting in a lower Pi release rate due to reduced filament-forming potential. The locations of mutations on the ACTC protein correlated with the molecular effects; in general, mutations in subdomain 3 affected the stability of the ACTC protein or affect the polymerization of actin filaments, while mutations in subdomains 1 and 4 more likely affect protein-protein interactions.

Actin filament subunit interfaces are required for the proper interaction between filamentous actin (F-actin) and actin binding proteins (ABPs). The production of small F-actin complexes mimicking such interfaces would be a significant advance toward understanding the atomic interactions between F-actin and its many binding partners. We produced actin lateral dimers and trimers derived from F-actin and rendered polymerization-deficient by ADP-ribosylation of Arg-177. The degree of modification resulted in a moderate reduction in thermal stability. Calculated hydrodynamic radii were comparable to theoretical values derived from recent models of F-actin. Filament capping capabilities were retained and yielded pointed-end dissociation constants similar those of wild-type actin, suggesting native or near-native interfaces on the oligomers. Changes in DNase I binding affinity under low and high ionic strength suggested a high degree of conformational flexibility in the dimer and trimer. Polymer nucleation activity was lost upon ADP-ribosylation and rescued upon enzyme-mediated deADP-ribosylation, or upon binding to gelsolin, suggesting that interactions with actin binding proteins can overcome the inhibiting activities of ADP-ribosylation. The combined strategy of chemical cross-linking and ADP-ribosylation provides a minimalistic and reversible approach to engineering polymerization-deficient F-actin oligomers that are able to act as F-actin binding protein scaffolds.

the heat capacity associated with the formation of the complex. The position of the peak gives the energy of the barrier. The peak position and width depend on lipid chain length and saturation and physicochemical properties of the membrane. The energy barrier is crucial to the determination of the level of enzymatic activity and is hypothesized to be the microscopic origin of the "interface quality effects". Results of activity measurements showing precisely the role of the barrier are presented.

Modification of actin at Cys (374) with tetramethylrhodamine maleimide (TMR-actin) has been used for visualization of actin filaments and to produce high-resolution crystal structures of actin. We show that TMR-actin exhibits a 21% decrease in absorbance at 557 nm upon thermal unfolding, likely due to the movement of TMR to a more hydrophobic environment upon rapid unfolding and protein aggregation. We took advantage of this property to test models of actin protein unfolding. A transition temperature ( T m) of 60.2 +/- 0.2 degrees C for Ca (2+).ATP.TMR-actin was determined using A 557 and agreed with our own determinations employing different techniques and previous work with unlabeled actin. Our data show that the dependence of TMR-actin thermal stability on the bound nucleotide and cations follows a trend of Ca (2+).ATP > Mg (2+).ATP > Ca (2+).ADP > Mg (2+).ADP. The activation energies and frequency factors for the thermal unfolding of TMR-actin determined with two methods were in good agreement with those previously determined for unlabeled actin. We observed a biphasic trend in the T m of TMR-actin with increasing nucleotide concentrations, supporting a two-pathway model for actin protein unfolding where one pathway dominates at different concentrations of nucleotide. Additionally, TMR-actin bound by DNase I or gelsolin segment-1 exhibited elevated transition temperatures.