Pebble Bed HTGR’s like the AVR in Ju¨lich have the advantage of continuous fuelling. However the multiple passes of the fuel pebbles through the core have the disadvantage that the pebble’s movement through the fuelling system and the core produces graphite dust. This dust is transported from the core to other parts of the primary circuit and deposits on components. Although previous experiments performed during AVR operation have given some insight into the dust particle size and activity, there is little information on the behaviour of the dust that was deposited in the system. The decommissioning of the AVR has provided the opportunity to sample and characterise such dust from a number of components and gauge the adhesion strength. From the side of PBMR Pty Ltd this opportunity is considered important to enhance the knowledge about dust characteristics before the PBMR Demonstration Power Plant (DPP) is operational and able to produce specific plant information through sampling and analysis. AVR GmbH has provided a number of pipes and joints for investigation of loose and bound dust. Phase 1 of the analysis was used to determine the best techniques to be used on larger items. No measurable loose dust could be collected. Thereupon rings were cut from a T-section and subdivided into eight segments. The surface of the untreated segments were photographed and documented by optical microscopy, the dose rates were measured and gamma-spectrometry performed. Following this a mechanical or chemical decontamination was carried out to remove and isolate the bound dust. The average isolated dust amount was about 2 mg/cm2. Both decontamination processes indicates a strong bonding of the dust surface layer. In the case of mechanical decontamination about 60% and by chemical decontamination about 95% of the radionuclide inventory could be removed. The contribution of removed metal needs to be investigated in more detail. The median number related particle size measured by optical microscopy was found to be in the range of 0.2 to 0.7 μm whereas the median weight related size is in the range of 0.8 to 1.5 μm. The initial results indicate that this dust sticks very strongly to the pipe surface. Phase 2 will concentrate on longer pieces of piping where hopefully more loose dust can be obtained and analysed. If the same strong bonding is observed the reason for this phenomenon needs to be explained and perhaps tested with non-active dust.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.