The clinical translation of pro-angiogenic growth factors for treatment of vascular disease has remained a challenge due to safety and efficacy concerns. Various approaches have been used to design spatiotemporally-controlled delivery systems for growth factors in order to recapitulate aspects of endogenous signaling and thus assist in translation. We have developed acoustically-responsive scaffolds (ARSs), which are fibrin scaffolds doped with a payload-containing, sonosensitive emulsion. Payload release can be controlled non-invasively and in an on-demand manner using focused, megahertz-range ultrasound (US). In this study, we investigate the in vitro and in vivo release from ARSs containing basic fibroblast growth factor (bFGF) encapsulated in monodispersed emulsions. Emulsions were generated in a two-step process utilizing a microfluidic device with a flow focusing geometry. At 2.5 MHz, controlled release of bFGF was observed for US pressures above 2.2 ± 0.2 MPa peak rarefactional pressure. Superthreshold US yielded a 12.6-fold increase in bFGF release in vitro. The bioactivity of the released bFGF was also characterized. When implanted subcutaneously in mice, ARS exposed to superthreshold US displayed up to 3.3-fold and 1.7-fold greater perfusion and blood vessel density, respectively, than ARS without US exposure. Scaffold degradation was not impacted by US. These results highlight the utility of ARSs in both basic and applied studies of therapeutic angiogenesis.

Hydrogel scaffolds are used in tissue engineering as a delivery vehicle for regenerative growth factors (GFs). Spatiotemporal patterns of GF signaling are critical for tissue regeneration, yet most scaffolds afford limited control of GF release, especially after implantation. We previously demonstrated that acoustic droplet vaporization (ADV) can control GF release from a fibrin scaffold doped with a perfluorocarbon emulsion. This study investigates properties of the acoustically responsive scaffold (ARS) critical for further translation. At 2.5 MHz, ADV and inertial cavitation thresholds ranged from 1.5 – 3.0 MPa and 2.0 – 7.0 MPa peak rarefactional pressure, respectively, for ARSs of varying compositions. Viability of C3H10T1/2 cells, encapsulated in the ARS, did not decrease significantly for pressures below 4 MPa. ARSs with perfluorohexane emulsions displayed higher stability versus perfluoropentane emulsions, while surrogate payload release was minimal without ultrasound. These results enable the selection of ARS compositions and acoustic parameters needed for optimized spatiotemporal control.

Spatiotemporally controlled release of growth factors (GFs) is critical for regenerative processes such as angiogenesis. A common strategy is to encapsulate the GF within hydrogels, with release being controlled via diffusion and/or gel degradation (i.e., hydrolysis and/or proteolysis). However, simple encapsulation strategies do not provide spatial or temporal control of GF delivery, especially non-invasive, on-demand controlled release post implantation. We previously demonstrated that fibrin hydrogels, which are widely used in tissue engineering and GF delivery applications, can be doped with perfluorocarbon emulsion, thus yielding an acoustically responsive scaffold (ARS) that can be modulated with focused ultrasound, specifically via a mechanism termed acoustic droplet vaporization. This study investigates the impact of ARS and ultrasound properties on controlled release of a surrogate payload (i.e., fluorescently-labeled dextran) and fibrin degradation in vitro and in vivo. Ultrasound exposure (2.5 MHz, peak rarefactional pressure: 8 MPa, spatial peak time average intensity: 86.4 mW/cm2), generated up to 7.7 and 21.7-fold increases in dextran release from the ARSs in vitro and in vivo, respectively. Ultrasound also induced morphological changes in the ARS. Surprisingly, up to 2.9-fold greater blood vessel density was observed in ARSs compared to fibrin when implanted subcutaneously, even without delivery of pro-angiogenic GFs. The results demonstrate the potential utility of ARSs in generating controlled release for tissue regeneration.

Regenerative processes, such as angiogenesis and osteogenesis, often require multiple growth factors with distinct spatiotemporal patterns and expression sequences. Within tissue engineering, hydrogel scaffolds are commonly used for exogenous growth factor delivery. However, direct incorporation of growth factors within conventional hydrogels does not afford spatiotemporally controlled delivery because release is governed by passive mechanisms that cannot be actively controlled after the scaffold is implanted. We have developed acoustically-responsive scaffolds (ARSs), which are fibrin scaffolds doped with payload-containing, sonosensitive emulsions. Payload release from ARSs can be controlled non-invasively and on demand using focused, megahertz-range ultrasound. In the in vitro study described here, we developed and characterized ARSs that enable sequential release of two surrogate, fluorescent payloads using consecutive ultrasound exposures at different acoustic pressures. ARSs were generated with various combinations and volume fractions of perfluoropentane, perfluorohexane, and perfluoroheptane emulsions. Acoustic droplet vaporization and inertial cavitation thresholds correlated with the boiling point/molecular weight of the perfluorocarbon while payload release correlated inversely. Payload release was longitudinally measured and observed to follow a sigmoidal trend versus acoustic pressure. Perfluoropentane and perfluorohexane emulsions were stabilized when incorporated into ARSs with perfluoroheptane emulsion. These results highlight the potential of using ARSs for sequential, dual-payload release for tissue regeneration.

Conventional tissue engineering approaches rely on scaffold-based delivery of exogenous proteins, genes, and/or cells to stimulate regeneration via growth factor signaling. However, scaffold-based approaches do not allow active control of dose, timing, or spatial localization of a delivered growth factor once the scaffold is implanted, yet these are all crucial parameters in promoting tissue regeneration. To address this limitation, we developed a stable cell line containing a heat-activated and rapamycin dependent gene expression system. In this study, we investigate how high intensity focused ultrasound (HIFU) can spatiotemporally control firefly luciferase (fLuc) transgene activity both in vitro and in vivo by the tightly controlled generation of hyperthermia. Cells were incorporated into composite scaffolds containing fibrin and hydroxyapatite particles, which yielded significant increases in acoustic attenuation and heating in response to HIFU compared to fibrin alone. Using 2.5 MHz HIFU, transgene activation was observed at acoustic intensities of 201 W/cm 2 and higher. Transgene activation was spatially patterned in the scaffolds by rastering HIFU at speeds up to 0.15 mm/s. In an in vivo study, a 67-fold increase in fLuc activity was

Localized delivery of nucleic acids to target sites (e.g., diseased tissue) is critical for safe and efficacious gene therapy. An ultrasound-based technique termed acoustic droplet vaporization (ADV) has been used to spatiotemporally control the release of therapeutic small molecules and proteins contained within sonosensitive emulsions. Here, ADV was used to control the release of lipoplex – containing plasmid DNA with an enhanced green fluorescent protein (eGFP) reporter - from a sonosensitive emulsion. Focused ultrasound (3.5 MHz, mechanical index (MI) ≥ 1.5) generated robust release of fluorescein (i.e., surrogate payload) and lipoplex from the emulsion. In situ release of the lipoplex from the emulsion using ADV (MI=1.5, 30 cycles) yielded a 55% release efficiency, resulting in 43% transfection efficiency and 95% viability with C3H/10T1/2 cells. Without exposure to ultrasound, the release and transfection efficiencies were 5% and 7%, respectively, with 99% viability. Lipoplex released by ADV retained its bioactivity while the ADV process did not yield any measureable sonoporative enhancement of transfection. Co-encapsulation of Ficoll PM 400 within the lipoplex loaded emulsion, and its subsequent release using ADV, yielded higher transfection efficiency than the lipoplex alone. The results demonstrate that ADV could have utility in the spatiotemporal control of gene delivery.

Recently, we demonstrated that ultrasound-based hyperthermia can activate cells containing a heat-activated and ligand-inducible gene switch in a spatio-temporally controlled manner. These engineered cells can be incorporated into hydrogel scaffolds (e.g., fibrin) for in vivo implantation, where ultrasound can be used to non-invasively pattern transgene expression. Due to their high water content, the acoustic attenuation of fibrin scaffolds is low. Thus, long ultrasound exposures and high acoustic intensities are needed to generate sufficient hyperthermia for gene activation. Here, we demonstrate that the attenuation of fibrin scaffolds and the resulting hyperthermia achievable with ultrasound can be increased significantly by doping the fibrin with hydroxyapatite (HA) nanopowder. The attenuation of a 1% (w/v) fibrin scaffold with 5% (w/v) HA was similar to soft tissue. Transgene activation of cells harboring the gene switch occurred at lower acoustic intensities and shorter exposures when the cells were encapsulated in HA-doped fibrin scaffolds versus undoped scaffolds. Inclusion of HA in the fibrin scaffold did not affect the viability of the encapsulated cells.

Hydrogel scaffolds are commonly used in tissue engineering as a substrate for cells or to deliver regenerative growth factors.We have previously demonstrated that acoustically responsive scaffolds can be developed by incorporating sonosensitive emulsions into hydrogel scaffolds. Growth factors, contained within the sonosensitive emulsions, can be released using ultrasound. Since ultrasound can be applied with both spatial and temporal control, this enables spatio-temporal release of growth factors within the ARS, which is unattainable with conventional hydrogel scaffolds. In this study, we expand this previous work by studying the thresholds associated with acoustic droplet vaporization (ADV) and inertial cavitation (IC) -two processes relevant to growth factor release. Acoustically-responsive scaffolds (ARS) were cast in OptiCells by doping fibrin hydrogels with perfluorocarbon droplets. ADV was generated in the ARS using a 2.5 MHz single element transducer. B-mode ultrasound was used to detect the onset of ADV whereas IC was detected with a broadband hydrophone. Results showed that ADV and IC thresholds are dependent on the number of acoustic cycles, the concentration of the ARS, and the structure of the droplets.