Here, ten guidelines are presented for a standardized definition of type I and II photosensitized oxidation reactions. Because of varied notions of reactions mediated by photosensitizers, a checklist of recommendations is provided for their definitions. Type I and type II photoreactions are oxygen-dependent and involve unstable species such as the initial formation of radical cation or neutral radicals from the substrates and/or singlet oxygen (1O2 1Δg) by energy transfer to molecular oxygen. In addition, superoxide anion radical (O2•−) can be generated by a charge transfer reaction involving O2 or more likely indirectly as the result of O2-mediated oxidation of the radical anion of type I photosensitizers. In subsequent reactions, O2•− may add and/or reduce a few highly oxidizing radicals that arise from the deprotonation of the radical cations of key biological targets. O2•− can also undergo dismutation into H2O2, the precursor of the highly reactive hydroxyl radical (•OH) that may induce delayed oxidation reactions in cells. In the second part several examples of type I and type II photosensitized oxidation reactions are provided to illustrate the complexity and the diversity of the degradation pathways of mostly relevant biomolecules upon one-electron oxidation and singlet oxygen reactions.

This Review describes singlet oxygen ((1)O2) in the organic synthesis of targets on possible (1)O2 biosynthetic routes. The visible-light sensitized production of (1)O2 is not only useful for synthesis; it is extremely common in nature. This Review is intended to draw a logical link between flow and batch reactions-a combination that leads to the current state of (1)O2 in synthesis.

The mechanism of the ene reaction of singlet ((1)delta(g)) oxygen with simple alkenes is investigated by a combination of experimental isotope effects and several levels of theoretical calculations. For the reaction of 2,4-dimethyl-3-isopropyl-2-pentene, the olefinic carbons exhibit small and nearly equal (13)C isotope effects of 1.005-1.007, while the reacting methyl groups exhibit (13)C isotope effects near unity. In a novel experiment, the (13)C composition of the product is analyzed to determine the intramolecular (13)C isotope effects in the ene reaction of tetramethylethylene. The new (13)C and literature (2)H isotope effects are then used to evaluate the accuracy of theoretical calculations. RHF, CASSCF(10e, 8o), and restricted and unrestricted B3LYP calculations are each applied to the ene reaction with tetramethylethylene. Each predicts a different mechanism, but none leads to reasonable predictions of the experimental isotope effects. It is concluded that none of these calculations accurately describe the reaction. A more successful approach was to use high-level, up to CCSD(T), single-point energy calculations on a grid of B3LYP geometries. The resulting energy surface is supported by its accurate predictions of the intermolecular (13)C and (2)H isotope effects and a very good prediction of the reaction barrier. This CCSD(T)//B3LYP surface features two adjacent transition states without an intervening intermediate. This is the first experimentally supported example of such a surface and the first example of a valley-ridge inflection with significant chemical consequences.

On the basis of ab initio calculations we propose a revised mechanism for the reaction of organic sulfides with singlet oxygen, which is more consistent with experimental evidence than previous schemes. In aprotic solvents the reagents initially form a weakly bound peroxysulfoxide, with a small barrier due to entropy. The peroxysulfoxide may decay back to ground state (triplet) oxygen, be trapped by sulfoxides, or rearrange to a S-hydroperoxysulfonium ylide with a barrier of ∼6 kcal/mol. The latter is ∼6 kcal/mol more stable than the peroxysulfoxide, and can be trapped by sulfides or rearrange to a sulfone. In some cases, like five-membered rings or benzylic sulfides, the S-hydroperoxysulfonium ylide may undergo a 1,2-OOH shift to an α-hydroperoxysulfide, which eventually leads to cleavage products. In protic solvents the peroxysulfoxide is rapidly converted to a sulfurane by solvent.

The chemistry of singlet molecular oxygen [1O2 (1Delta g)], its importance in atmospheric, biological, and therapeutic processes, and its use as a reagent in organic synthesis have been of considerable interest. Many aspects of singlet oxygen chemistry have emanated from the work of Christopher S. Foote and co-workers. Singlet oxygen is a historically interesting molecule with an unusual story connected with its discovery. Foote and Wexler conducted experiments in the 1960s where evidence was obtained supporting 1O2 generation via two independent routes: (1) a photochemical reaction (dye-sensitized photooxidation) and (2) a chemical reaction (NaOCl with H2O2). An important factor in the discovery of 1O2 as the critical reaction intermediate in dye-sensitized photooxygenations was Foote's reassessment of the chemical literature of the 1930s, when 1O2 was suggested to be a viable intermediate in dye-sensitized photooxidation reactions. Experiments that used silica gel beads provided evidence for a volatile diffusible oxidant such as 1O2. However, a contemporaneous quarrel surrounded this early work, and the possible existence of solution-phase 1O2 was ignored for over 2 decades. Not long after Foote's initial studies were published in 1964, the idea of singlet oxygen as an intermediate in photooxidation chemistry gained increasing recognition and verification in organic, gas phase, and biological processes. There are many documented impacts that 1O2 has had and continues to have on biology and medicine, for example, photodynamic therapy and plant defenses.

Photosensitization reactions have been demonstrated to be largely responsible for the deleterious biological effects of UV and visible radiation, as well as for the curative actions of photomedicine. A large number of endogenous and exogenous photosensitizers, biological targets and mechanisms have been reported in the past few decades. Evolving from the original definitions of the type I and type II photosensitized oxidations, we now provide physicochemical frameworks, classifications and key examples of these mechanisms in order to organize, interpret and understand the vast information available in the literature and the new reports, which are in vigorous growth. This review surveys in an extended manner all identified photosensitization mechanisms of the major biomolecule groups such as nucleic acids, proteins, lipids bridging the gap with the subsequent biological processes. Also described are the effects of photosensitization in cells in which UVA and UVB irradiation triggers enzyme activation with the subsequent delayed generation of superoxide anion radical and nitric oxide. Definitions of photosensitized reactions are identified in biomolecules with key insights into cells and tissues.

No abstract

A liquid-phase photolysis of 1,2-benzodiphenylene sulfoxide, 1, and dibenzothiophene sulfoxide, 2, was used to generate atomic oxygen [O(3P)] or an equivalent active oxygen species. The reaction for sulfoxide photodeoxygenation was similar to a microwave discharge method for generating O(3P) atoms in the condensed phase (Zadok, E.; Rubinraut, S.; Mazur, Y. J. Org. Chem. 1987, 52, 385-90). Sulfoxide photodeoxygenation is a potentially clean method for O(3P) production compared to the microwave discharge method. With Argon purging of the sulfoxide sample before photolysis, the method can preclude a secondary oxidation process involving molecular oxygen. Our study focused on the results of oxidation products in the reaction of styrene, 3, and on the dependence of substrates that provided an opportunity to vary the electronic and steric effects. The sulfoxide photochemistry is rationalized with the primary formation of O(3P) in which a charge-transfer interaction between O(3P) and substrate precedes oxidation. Functionalization of hydrocarbons takes place under mild photolysis conditions of 1 and 2, which leads to an interesting possibility for the synthetic use of atomic oxygen, O(3P). Alkanes give principally alcohols. Alkenes give principally epoxides and ketones. For comparison, hydroxyl radicals are more reactive and less selective toward hydrocarbons compared to O(3P) atoms. On the other hand, O(3P) atoms balance reactivity and selectivity and involve the oxidation of inert alkanes typically inaccessible to peracid, dioxirane, ozone, and singlet molecular oxygen chemistry. The findings from this study may be useful to those interested in generating high-value oxygenated compounds from readily available petroleum components.