ranged with the type of growth, maturity group, location, and sowing date.

The objective of this study was to determine the cardinal temperatures for the planting-emergence phase of gladiolus. A controlled environment experiment was performed in a growth chamber in the Universidade Federal do Pampa - Campus Itaqui, using the completely randomized experimental design with 12 temperature treatments (5°C, 7°C, 10°C, 13°C, 16°C, 18°C, 20°C, 22°C, 25°C, 30°C, 33°C, 35°C) and ten replicates. Corms of the cultivar ‘Amsterdam’ were planted at a depth of 10cm in 1.7dm3 pots. Every day the date of emergence of the gladiolus plants was observed. Then for each treatment, the emergence rate was calculated as the inverse of the duration of the budding phase, and estimated data were achieved employing the non-linear model of simulation. The lower base and upper base temperatures were identified at the non-emergence temperatures. To estimate the optimum temperature, the root of mean square error was used. Between 22 and 25ºC the planting-emergence phase was reported to be completed in a shorter time span, although the smaller root mean square error was achieved at 22.5ºC. The cardinal temperatures of the planting-emergence phase of gladiolus, lower base, optimum and upper base temperature were 5°C, 22.5°C and 35°C, respectively.

-The objective of this work was to evaluate methods of thermal time calculation and the duration of the development stages of lowland rice (Oryza sativa) irrigated by sprinkling. The experiment was conducted during three growing seasons (2010/2011, 2011/2012, and 2014/2015), with five irrigation water depths, six cultivars, and four replicates. Six methods of thermal time calculation were tested: two using the minimum basal temperature; two using the minimum and optimum temperatures; and two using the minimum, optimum, and maximum basal temperatures. For the thermal time calculation, the crop development cycle was divided into the vegetative, reproductive, and grain-filling phases. The methods that used the three cardinal temperatures showed the lowest coefficients of variation for most of the developmental phases. Both irrigation water depths and rice cultivars affected the thermal time of the development stages. The greater the water availability, the lower the duration of the development cycle. Thermal time values depend on the calculation method.

The objective of this study is to analyze the classification of rice grains of lowland cultivars grown under flood and sprinkler irrigation. The study was carried out in the agricultural years 2011/2012 and 2014/2015 using a completely randomized block design with split plots. In 2011/2012, the treatments were three lowland rice cultivars grown under flood irrigation system and five sprinkler irrigation depths with four replications. In 2014/2015, the experimental design was maintained but flood irrigation was not performed. After harvest, the samples were processed in a rice testing machine, including peeling, polishing and classification. Whole and broken grains were weighed to calculate hulling and milling yield. The classifications followed the guidelines described in Normative Instruction No. 6 of the Ministry of Agriculture, Livestock, and Supply of Brazil. In 2011/2012, there was interaction between sprinkler irrigation depths and the cultivars on hulling and milling yield, and in 2014/2015, there was significant difference in hulling yield between the cultivars. Genetic characteristics and water availability affected the classification of rice grains grown under sprinkler irrigation. In two sprinkler irrigation depths, the quality of the grains was similar to flood irrigation system. The highest milling yield was obtained in cultivar IRGA 417.