The aim of this work is to characterize the rheological and permeability behavior of nanocomposites based on amorphous poly(ethylene terephthalate) (PETg) and organically modified montmorillonites (omMMT), obtained by melt intercalation. The use of PETg instead of semicrystalline PET is believed to reduce the risks associated to organic modifier degradation during processing at high temperatures. X-ray and transmission electron microscopy analysis performed on the PETg nanocomposites showed that processing for long time at temperatures lower than melting of semicrystalline PET allowed to obtain a partially intercalated structure with some degree of exfoliation. The rheological behavior of PETg nanocomposites was studied as a function of shear rate in a coneplate rheometer in order to correlate the viscosity with the aggregation state of omMMT. A simple model accounting for an apparent increase of rheological units size, associated with the intercalation of PETg macromolecules into omMMT galleries, is proposed. The glass transition temperature, T g , as a function of the volume fraction of omMMT content of the nanocomposite, was measured using differential scanning calorimetry. Finally, the water vapour permeability of PETg nanocomposites was correlated to the volume fraction of the impermeable inorganic part of the omMMT.
This work aims at studying the creep behaviour of 15-15Ti(Si) austenitic steel, under uniaxial stress (range of 300-560 MPa), and its interaction with liquid lead. The steel was tested to verify its sensitivity to Liquid Metal Embrittlement (LME) and to simulate its behaviour in operating thermal and mechanical stress conditions of the IV generation Lead-cooled fast reactor. The experimental results permitted to plot the time-strain creep curve and the characteristic Norton-based curve, simulating the creep behaviour at all stress values. The comparison between the creep curves in air and in lead showed that the LME produces a decrease of creep-rupture time, a reduction of creep strain and then the loss of steel ductility. Moreover, the raw material and fracture surfaces were analyzed by Optical Microscope and Scanning Electron Microscope (SEM). SEM micrographs highlighted that lead changes both the mode and the type of specimen fracture. In addition, it was analyzed the lead action time, as the time after which the corrosion appears with macroscopic effects. Although some tests are still ongoing, it can be assumed that at high stresses, LME takes place after a long time of steel/lead contact while at low stresses, LME tends to prevail on creep effect.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.