Dialkyl phosphate esters used as gellants in some oil well fracturing processes for conventional oil production can result in contamination of the collected crude. Though the exact mechanism is unclear, such compounds form volatile phosphorus that compromises refinery processes. Our initial research involved producing a comprehensive two-dimensional gas chromatographic method (GC × GC) for the detection and quantification of alkyl phosphate esters in petroleum samples, which surpassed the current method employed in sensitivity and speciation capabilities. However, selective detection is required for such analytes in petroleum matrices. This article describes the application of GC × GC with time-of-flight mass spectrometry for selective detection to the analysis of di- and tri-alkyl phosphates in petroleum samples. Features in the electron impact mass spectra of alkyl phosphates are discussed along with the GC × GC retention characteristics of the compounds. Based on these discussions, a preliminary classification and quantification of alkyl phosphate contamination in a suite of industrial samples is then presented.

Dialkyl phosphate esters are used as gellants in some oil well fracturing processes for conventional oil production. Residual amounts of these compounds that remain in the well represent a source of potential contamination of the crude oil produced from the well. This contamination results in fouling of refinery equipment. Current methodologies for the analysis of alkyl phosphates have a relatively poor detection limit (0.5 AE 1.0 mg mL À1 ) and provide no speciation information: only a total phosphorus concentration. Herein, we present an approach that permits speciation of individual alkyl phosphates and quantification of individual compounds with limits of detection and precision that represent an improvement on the existing methodology. The method that we present relies upon derivatization of dialkyl phosphates to their trimethylsilane (TMS) esters followed by a comprehensive two-dimensional gas chromatographic separation. Two dialkyl phosphate esters, dibutyl and bis(2ethylhexyl) phosphate were used as model compounds. Recovery of spiked samples in pure solvent and a model petroleum mixture ranged from 92% to 120%. This approach represents a significant first step in the development of an analytical solution to the challenge of phosphorus contamination facing the oil industry.