The design of critical facilities needs a targeted computation of the expected ground motion levels. The Trans Adriatic Pipeline (TAP) is the pipeline that transports natural gas from the Greek-Turkish border, through Greece and Albania, to Italy. We present here the probabilistic seismic hazard analysis (PSHA) that we performed for this facility, and the deaggregation of the results, aiming to identify the dominant seismic sources for a selected site along the Albanian coast, where one of the two main compressor stations is located. PSHA is based on an articulated logic tree of twenty branches, consisting of two models for source, seismicity, estimation of the maximum magnitude, and ground motion. The area with the highest hazard occurs along the Adriatic coast of Albania (PGA between 0.8 and 0.9 g on rock for a return period of 2475 years), while strong ground motions are also expected to the north of Thessaloniki, Kavala, in the southern Alexandroupolis area, as well as at the border between Greece and Turkey. The earthquakes contributing most to the hazard of the test site at high and low frequencies (1 and 5 Hz) and the corresponding design events for the TAP infrastructure have been identified as local quakes with MW 6.6 and 6.0, respectively.

In recent years, new approaches for developing earthquake rupture forecasts (ERFs) have been proposed to be used as an input for probabilistic seismic hazard assessment (PSHA). Zone- based approaches with seismicity rates derived from earthquake catalogs are commonly used in many countries as the standard for national seismic hazard models. In Italy, a single zone- based ERF is currently the basis for the official seismic hazard model. In this contribution, we present eleven new ERFs, including five zone-based, two smoothed seismicity-based, two fault- based, and two geodetic-based, used for a new PSH model in Italy. The ERFs were tested against observed seismicity and were subject to an elicitation procedure by a panel of PSHA experts to verify the scientific robustness and consistency of the forecasts with respect to the observations. Tests and elicitation were finalized to weight the ERFs. The results show a good response to the new inputs to observed seismicity in the last few centuries. The entire approach was a first attempt to build a community-based set of ERFs for an Italian PSHA model. The project involved a large number of seismic hazard practitioners, with their knowledge and experience, and the development of different models to capture and explore a large range of epistemic uncertainties in building ERFs, and represents an important step forward for the new national seismic hazard model.

The rapid estimation of expected impacts in case of an earthquake is extremely important for emergency managers and first responders. Current near-real-time damage assessment methods rely on ground-motion estimates and exposure or fragility datasets, in some cases integrating the shaking recorded at the site (e.g., from strong-motion monitoring networks). We propose a method that estimates the expected damages on buildings based on strong-motion recordings of a seismic event. The damage assessment is based on the maximum drift (interstory) or the displacement, which is estimated by considering in a first approximation the behavior of a specific building typology as a single-degree-of-freedom oscillator. The oscillator is characterized based on the analysis of the building stock and a large number of ambient vibration measurements performed in buildings. A specific damage state occurs when the interstory drift or displacement limits available in the literature for the specific building typology are exceeded. The method, here applied to a case study in northeastern Italy, can be applied to other seismic areas worldwide to provide quick, first-level estimates of expected damages.

No abstract

We investigated the spatial relationships among 18 known seismogenic faults and 1651 wells drilled for gas exploitation in the main hydrocarbon province of northern-central Italy, a unique dataset worldwide. We adopted a GIS approach and a robust statistical technique, and found a significant anticorrelation between the location of productive wells and of the considered seismogenic faults, which are often overlain or encircled by unproductive wells. Our observations suggest that (a) earthquake ruptures encompassing much of the upper crust may cause gas to be lost to the atmosphere over geological time, and that (b) reservoirs underlain by smaller or aseismic faults are more likely to be intact. These findings, which are of inherently global relevance, have crucial implications for future hydrocarbon exploitation, for assessing the seismic–aseismic behaviour of large reverse faults, and for the public acceptance of underground energy and CO2 storage facilities—a pillar of future low carbon energy systems—in tectonically active areas.