We encounter optimization problems in our daily lives and in various research domains. Some of them are so hard that we can, at best, approximate the best solutions with (meta-) heuristic methods. However, the huge number of optimization problems and the small number of generally acknowledged methods mean that more metaheuristics are needed to fill the gap. We propose a new metaheuristic, called chemical reaction optimization (CRO), to solve optimization problems. It mimics the interactions of molecules in a chemical reaction to reach a low energy stable state. We tested the performance of CRO with three nondeterministic polynomial-time hard combinatorial optimization problems. Two of them were traditional benchmark problems and the other was a real-world problem. Simulation results showed that CRO is very competitive with the few existing successful metaheuristics, having outperformed them in some cases, and CRO achieved the best performance in the realworld problem. Moreover, with the No-Free-Lunch theorem, CRO must have equal performance as the others on average, but it can outperform all other metaheuristics when matched to the right problem type. Therefore, it provides a new approach for solving optimization problems. CRO may potentially solve those problems which may not be solvable with the few generally acknowledged approaches.

This paper addresses the problem of voltage regulation in power distribution networks with deep-penetration of distributed energy resources, e.g., renewable-based generation, and storage-capable loads such as plug-in hybrid electric vehicles. We cast the problem as an optimization program, where the objective is to minimize the losses in the network subject to constraints on bus voltage magnitudes, limits on active and reactive power injections, transmission line thermal limits and losses. We provide sufficient conditions under which the optimization problem can be solved via its convex relaxation. Using data from existing networks, we show that these sufficient conditions are expected to be satisfied by most networks. We also provide an efficient distributed algorithm to solve the problem. The algorithm adheres to a communication topology described by a graph that is the same as the graph that describes the electrical network topology. We illustrate the operation of the algorithm, including its robustness against communication link failures, through several case studies involving 5-, 34-and 123-bus power distribution systems.

No abstract

To enhance environmental sustainability, many countries will electrify their transportation systems in their future smart city plans. So the number of electric vehicles (EVs) running in a city will grow significantly. There are many ways to recharge EVs' batteries and charging stations will be considered as the main source of energy. The locations of charging stations are critical; they should not only be pervasive enough such that an EV anywhere can easily access a charging station within its driving range, but also widely spread so that EVs can cruise around the whole city upon being re-charged. Based on these new perspectives, we formulate the Electric Vehicle Charging Station Placement Problem (EVCSPP) in this paper. We prove that the problem is non-deterministic polynomial-time hard. We also propose four solution methods to tackle EVCSPP and evaluate their performance on various artificial and practical cases. As verified by the simulation results, the methods have their own characteristics and they are suitable for different situations depending on the requirements for solution quality, algorithmic efficiency, problem size, nature of the algorithm, and existence of system prerequisite.

No abstract

Chemical Reaction Optimization (CRO) is a recently established metaheuristics for optimization, inspired by the nature of chemical reactions. A chemical reaction is a natural process of transforming the unstable substances to the stable ones. In microscopic view, a chemical reaction starts with some unstable molecules with excessive energy. The molecules interact with each other through a sequence of elementary reactions. At the end, they are converted to those with minimum energy to support their existence. This property is embedded in CRO to solve optimization problems. CRO can be applied to tackle problems in both the discrete and continuous domains. We have successfully exploited CRO to solve a broad range of engineering problems, including the quadratic assignment problem, neural network training, multimodal continuous problems, etc. The simulation results demonstrate that CRO has superior performance when compared with other existing optimization algorithms. This tutorial aims to assist the readers in implementing CRO to solve their problems. It also serves as a technical overview of the current development of CRO and provides potential future research directions.

Abstract-Optimal power flow (OPF) is an important problem for power generation and it is in general non-convex. With the employment of renewable energy, it will be desirable if OPF can be solved very efficiently so its solution can be used in real time. With some special network structure, e.g. trees, the problem has been shown to have a zero duality gap and the convex dual problem yields the optimal solution. In this paper, we propose a primal and a dual algorithm to coordinate the smaller subproblems decomposed from the convexified OPF. We can arrange the subproblems to be solved sequentially and cumulatively in a central node or solved in parallel in distributed nodes. We test the algorithms on IEEE radial distribution test feeders, some random tree-structured networks, and the IEEE transmission system benchmarks. Simulation results show that the computation time can be improved dramatically with our algorithms over the centralized approach of solving the problem without decomposition, especially in tree-structured problems. The computation time grows linearly with the problem size with the cumulative approach while the distributed one can have sizeindependent computation time.

Abstract-Online identification of post-contingency transient stability is essential in power system control, as it facilitates the grid operator to decide and coordinate system failure correction control actions. Utilizing machine learning methods with synchrophasor measurements for transient stability assessment has received much attention recently with the gradual deployment of wide-area protection and control systems. In this paper, we develop a transient stability assessment system based on the long short-term memory network. By proposing a temporal self-adaptive scheme, our proposed system aims to balance the trade-off between assessment accuracy and response time, both of which may be crucial in real-world scenarios. Compared with previous work, the most significant enhancement is that our system learns from the temporal data dependencies of the input data, which contributes to better assessment accuracy. In addition, the model structure of our system is relatively less complex, speeding up the model training process. Case studies on three power systems demonstrate the efficacy of the proposed transient stability assessment system. Index Terms-Transient stability assessment, long short-term memory, phasor measurement units, voltage phasor, recurrent neural network.