Z-scheme photocatalytic reaction is considered an effective strategy to promote the photogenerated electron-hole separation for significantly improving the efficiency of photocatalytic hydrogen precipitation from splitting water. In this study, a heterojunction nanocomposite material based on Zn3V2O8 (ZV) with MWCNT was prepared by a hydrothermal process. The photocatalysts were characterized by X-ray diffraction, scanning electron microscopy (SEM), Fourier transform infrared (FTIR), UV-visible absorption spectroscopy, and transmission electron microscopy (TEM) to understand crystal structure, morphology, and optical properties. The efficiency of the samples was evaluated for the photocatalytic H2 production under visible solar radiation using water glycerol as a sacrificial reagent. The obtained results suggest that, between ZV and ZV@MWCNT, the latter shows higher efficiency for H2 production. The maximum H2 production efficiency was found to be 26.87 μmol g–1 h–1 for ZV and 99.55 μmol g–1 h–1 for ZV@MWCNT. The synergistic effect of MWCNT to ZV resulted in improving the efficiency of charges and light-absorbing capacity, resulting in enhanced H2 production in the heterojunction nanocomposite material. The nanocomposite was stable and highly efficient for H2 production of six or more cycles. Based on the outcomes of this study, it can be observed that forming the heterojunction of individual nano systems could result in more efficient material for H2 production under visible solar energy.

The contamination of water is increasing day by day due to the increase of urbanization and population. Textile industries contribute to this by discarding their waste directly into water streams without proper treatment. A recent study explores the treatment potential of copper oxide nanorods (CuO NRs) synthesized on a green basis in the presence of a biopolymer matrix of agar (AA) and alginate (Alg), in terms of cost effectiveness and environmental impact. The synthesized bio nanocomposite (BNC) was characterized by using different instrumental techniques such as Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), ultra-violet spectroscopy (UV-Vis), scanning electron microscopy-energy dispersive X-ray-elemental analysis (SEM-EDX), transmission electron microscopy (TEM), selected area diffraction pattern (SAED) and X-ray photoelectron spectroscopy (XPS). The optical studies revealed that immobilization of CuO NRs with Alg-Agar biopolymer blend resulted in an increase in light absorption capacity by decreasing the energy bandgap from 2.53 eV to 2.37 eV. The bio nanocomposite was utilized as a photocatalyst for the degradation of amaranth (AN) dye from an aquatic environment under visible light irradiation. A statistical tool known as central composite design (CCD) associated with response surface methodology (RSM) was taken into consideration to evaluate the optimized values of process variables and their synergistic effect on photocatalytic efficiency. The optimized values of process variables were found to be irradiation time (45 min), AN concentration (80 ppm), catalyst dose (20 mg), and pH (4), resulting in 95.69% of dye degradation at 95% confidence level with desirability level 1. The rate of AN degradation was best defined by pseudo-first-order reaction based on the correlation coefficient value (R2 = 0.99) suggesting the establishment of adsorption-desorption equilibrium initially at the catalyst surface then photogenerated •O2– radicals interacting with AN molecule to mineralize them into small non-toxic entities like CO2, H2O. The material used has high efficiency and stability in photocatalytic degradation experiments up to four cycles of reusability.

The monoclinic nanocrystalline Ni1−xMnxWO4 heterostructure has been successfully synthesized by the hydrothermal technique for achieving better sensitive and photocatalytic performances. Different characterization techniques such as X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), ultraviolet-visible (UV–Vis), and photoluminescence (PL) spectroscopy have been employed to investigate their structural, microstructural, and optical properties. Mn-ion incorporation in the NiWO4 lattice reduces the particle size of the sample compared with the pure undoped NiWO4 sample, which has been confirmed from the transmission electron microscope image. The Tauc plot of the Ni1−xMnxWO4 sample exhibits a significant decrease in bandgap energy compared with the pure undoped NiWO4 sample due to the quantum confinement effect. Finally, the material was explored as a photocatalyst for the degradation of methyl orange (MO) dye from wastewater under visible light irradiation. Various reaction parameters such as pH, catalyst dose, reaction time, and kinetics of the photodegradation were studied using the batch method. The results showed that the Ni1−xMnxWO4 is highly efficient (94.51%) compared with undoped NiWO4 (65.45%). The rate of photodegradation by Ni1–xMnxWO4 (0.067) was found to be 1.06 times higher than the undoped NiWO4 (0.062).

In the present study, pristine ZnWO4, CoWO4, and mixed metal Zn0.5Co0.5WO4 were synthesized through the hydrothermal process using a Teflon-lined autoclave at 180 ℃. The synthesized nanomaterials were characterized by various spectroscopic techniques, such as TEM, FTIR, UV–vis, XRD, and SEM-EDX-mapping to confirm the formation of nanocomposite material. The synthesized materials were explored as photocatalysts for the degradation of xylenol orange (XO) under a visible light source and a comparative study was explored to check the efficiency of the bimetallic co-doped nanocomposite to the pristine metal tungstate NPs. XRD analysis proved that reinforcement of Co2+ in ZnWO4 lattice results in a reduction in interplanar distance from 0.203 nm to 0.185 nm, which is reflected in its crystallite size, which reduced from 32 nm to 24 nm. Contraction in crystallite size reflects on the optical properties as the energy bandgap of ZnWO4 reduced from 3.49 eV to 3.33 eV in Zn0.5Co0.5WO4, which is due to the formation of a Z-scheme for charge transfer and enhancement in photocatalytic efficiency. The experimental results suggested that ZnWO4, CoWO4, and Zn0.5Co0.5WO4 NPs achieved a photocatalytic efficiency of 97.89%, 98.10%, and 98.77% towards XO in 120 min of visible solar light irradiation. The kinetics of photodegradation was best explained by pseudo-first-order kinetics and the values of apparent rate const (kapp) also supported the enhanced photocatalytic efficiency of mixed metal Zn0.5Co0.5WO4 NPs towards XO degradation.

The discharge of pharma products such as paracetamol (PCT) into water has resulted in great harm to humans and emerged as a potential threat requiring a solution. Therefore, the development of smart and efficient materials as photocatalysts has become imperative in order to treat PCT in wastewater. The present study demonstrates the synthesis of pristine NiWO4 and CoWO4 and a heterojunction nanostructure, NiWO4/CoWO4, through a hydrothermal process using a Teflon-lined autoclave at 180 ℃ for 18 h. Various spectroscopic techniques, such as X-ray diffraction (XRD), Fourier transform infrared (FTIR), ultraviolet–visible (UV–Vis), transmission electron microscopy (TEM), scanning electron microscopy–energy dispersive X-ray (SEM–EDX), and X-ray photoelectron spectroscopy (XPS) were utilised to determine the lattice, structural, optical, and morphological information of the solid nanomaterial upon heterojunction formation. The synthesised nanomaterials were exploited for the photocatalytic degradation of paracetamol (PCT) under UV light irradiation. Photocatalytic experiments were performed for the optimization of various reaction parameters, such as irradiation time, pH, catalyst dose, and PCT concentration at room temperature. The results obtained suggested that the heterojunction nanocomposite NiWO4/CoWO4 exhibited enhanced photocatalytic efficiency (97.42%) with PCT as compared to its precursors—96.50% for NiWO4 and 97.12% for CoWO4. The photocatalytic data were best defined by the Langmuir–Hinshelwood (L–H) model of pseudo-first-order kinetics, with apparent rates constant at 0.015 min−1 for NiWO4, 0.017 min−1 for CoWO4, and 0.019 min−1 for NiWO4/CoWO4 NC. It was observed that NiWO4/CoWO4 NC with enhanced optical properties effected a higher rate of PCT degradation due to the improved bandgap energy upon heterojunction formation. The scavenger test revealed the involvement of •OH radicals as reactive oxidant species (ROS) in PCT degradation. The material was found to be highly stable and reusable for the degradation of PCT at optimized reaction conditions.