In this paper, we describe an experimental study of concrete behavior under a uniaxial tensile load by use of the thermally-compensated Coda Wave Interferometry (CWI) analysis. Under laboratory conditions, uniaxial tensile load cycles are imposed on a cylindrical concrete specimen, with continuous ultrasonic measurements being recorded within the scope of bias control protocols. A thermally-compensated CWI analysis of multiple scattering waves is performed in order to evaluate the stress-induced velocity variation. Concrete behavior under a tensile load can then be studied, along with CWI results from both its elastic performance (acoustoelasticity) and plastic performance (microcracking corresponding to the Kaiser effect). This work program includes a creep test with a sustained, high tensile load; the acoustoelastic coefficients are estimated before and after conducting the creep test and then used to demonstrate the effect of creep load.

No abstract

An ultrasonic method providing for an efficient global detection of defects in complex media (multiple scattering or reverberating media) is reported herein; this method is based on the nonlinear acoustic mixing of coda waves (stemming from multiple scattering) with lower frequency-swept pump waves. Such a nonlinear mixing step is made possible by the presence of nonlinear scatterers, such as cracks and delamination, yet remains absent when the waves are scattered only by linear scatterers, as is the case in a complex but defect-free medium. A global inspection is achieved thanks to the use of wide-band coda and pump signals, which ensure the excitation of many resonances along with a homogeneous acoustic energy distribution in the medium. We introduce the existing sensitivity tools developed for Coda Wave Interferometry in extracting the pump amplitude-dependent parameters of the coda waves associated with effective nonlinear parameters of the medium. By comparing results at two damage levels, these effective nonlinear parameters are shown to be correlated with crack presence in glass samples. The mechanisms potentially responsible for the observed amplitude dependence on the tested elastic parameters and waveform modification are discussed.