The purpose of the current study was to investigate the effect of a chemical disinfectant (sodium hypochlorite 5.25 %) on color stability of a denture base acrylic resin and two processed soft denture lining materials of two different types (acrylic-based and silicone-based). Ten specimens from each type of materials tested were made (2 × 20 × 20 mm). All specimens were immersed in sodium hypochlorite (5.25 %). Colorimetric measurements for each specimen were taken before immersion, and after 24 h and 7 days of immersion. Color changes were evaluated using the CIE L*a*b* colorimetric system. Data were statistically analyzed with one-way analysis of variance (ANOVA) (α = 0.05). ANOVA was followed by Bonferroni test to determine which groups differed from each other. ΔE and ΔL* of the silicone-based liner at the 1st and 7th days of immersion were significantly more than of denture base acrylic resin and acrylic-based liner. Change in ΔL* values of denture base acrylic resin and acrylic-based liner was small and statistically insignificant after 24 h of its immersion. However, the increase in ΔL* values of the acrylic-based liner after 7 days of immersion was considerably more than of denture base acrylic resin. Color changes in denture base acrylic resin and soft denture liners tended to increase with longer immersion times, and the color stability of the soft denture liners was influenced by its chemical type.
The study results indicate that the use of dental stone or a 50:50 mixture of plaster and stone for investing of dentures is an important factor in efforts to control the magnitude of tooth movement.
The purpose of this study was evaluation the effect of immersion in distilled water and inorganic artificial saliva on the shear bond strength of a heat-polymerized and an auto-polymerized silicone-based denture lining materials. The denture liners investigated were Molloplast-B (heat-polymerized), and Mollosil plus (auto-polymerized). The soft liner specimens were 10 × 10 × 2.5 mm and were processed between two poly(methylmethacrylate) plates. Thirty shear specimens for each type of test lining material were prepared. Specimens were divided equally into three groups for each test lining material: first group, specimens were tested after 48 h of preparation without immersion; second group, specimens were tested following immersion in distilled water at 37 °C for 12 months; and third group, specimens were tested following immersion in inorganic artificial saliva at 37 °C for 12 months. Shear bond strength was measured using an universal testing machine at a crosshead speed of 40 mm/min and failure mode (adhesive, cohesive and mixed) after debonding was assessed. Data were statistically analyzed with one-way analysis of variance (ANOVA) (α = 0.05). ANOVA was followed by Bonferroni post hoc tests for pairwise comparisons. A significant difference in shear bond strength was detected between Molloplast-B and Mollosil plus following immersion in distilled water and artificial saliva. Molloplast-B demonstrated considerably higher shear strength than Mollosil plus after immersion. Shear strengths of the lining materials investigated reduced significantly after immersion in both solutions. Visual examination after separation revealed that the soft materials tested exhibited mostly adhesive failure. The effect of immersion in distilled water and inorganic artificial saliva on bond strength of test lining materials was perceivable; however, both of them had acceptable bond strength and might be proper for long-term use.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.