Objective: This study aimed to determine whether orthodontically moved maxillary canines exposed to two different protocols and dosage of LLLT exhibited differences in amount and rate of tooth movement. Materials and Methods: Fifteen patients, 12 females and 3males, with mean age of 17.48 ± 2.95 years were included. They had a clinical indication for bilateral extraction of first maxillary premolars. Using a split mouth design, maxillary left and right sides were randomly divided into two groups. In group 1, LLLT delivered at 10 points; 5 from buccal and 5 from palatal aspects with total dose of 8 J/session. In group II, laser applied from buccal side only at 5 points with dose of 4 J per session. In both protocols, gallium aluminum-arsenide diode laser applied in continuous mode with 635 nm, 100 mW, 25 J/cm 2 , 8 seconds/ point, 0.8 J/point. Amount and rate of maxillary canine retraction and degree of anchorage loss were determined by intraoral and three-dimensional digital models measurements. Results: Clinical and model evaluations demonstrated no significant difference (p < 0.05) between both groups. After 24 weeks, total amounts of canine retraction were 6.86±1.60 mm and 6.65±1.59 mm in group I and group II, respectively. Moreover, anchorage loss displayed-0.35 mm ± 0.18 mm in group I and-0.44 mm± 0.24 mm in group II. Conclusion: With the current settings, both protocols and energy doses of LLLT accomplished comparable amount and rate of maxillary canine retraction. Additionally, they displayed an equivalent minimal degree of anchorage loss.

Aim: To compare the clinical and 3D volumetric socket bone preservation using Beta tri-calcium pohosphate plus collagen (B-TCP/Col) versus Platelet Rich Fibrin (PRF) assessed by 3D cone beam computed tomography. Subjects and Methods: 20 patients were treatment planned for extraction of mandibular and maxillary teeth, leaving 20 sockets for the study. Sockets were divided into 2 groups, each group consisting of 10 sockets. Sockets were grafted as follows: Group (I) sockets were grafted with B-TCP/col, Group (II) sockets were grafted with PRF. Cone beam computed tomography (CBCT) were done immediately and 3 months postoperatively, then collected data were statistically analyzed. Results: After 3 months, Bone height (mm) showed significant difference between the tested groups where Group A (B-TCP) produced the highest mean Bone height followed by Group B (PRF). Bone width (mm) showed insignificant differences between the tested groups. Bone density showed insignificant differences between the tested groups. Conclusion: Beta tri calcium pohosphate plus collagen (B-TCP/Col) may be a adjunctive modality to accelerate bone formation in defective socket.