In the present study, real car wash wastewater was purified by different coagulation/flocculation methods. As coagulant, polyaluminum chloride (‘BOPAC’), conventional iron(III) chloride, iron(III) sulfate, and aluminum(III) chloride were used, while as flocculant non-ionic and anionic polyelectrolytes were investigated. The effects of added clay mineral (Na-bentonite) and cationic surfactant (hexadecyltrimethyl ammonium bromide – ‘HTABr’) were also investigated. The use of BOPAC was significantly more effective than conventional coagulants. Extra addition of clay mineral was also beneficial in relation to both the sediment volume and sedimentation speed, while polyelectrolyte addition enhanced further the sedimentation. Moreover, the simultaneous addition of HTABr significantly enhanced the color removal efficiency due to the successful in-situ generation of organophilic bentonite. In summary, the application of 100 mg L−1 Na-bentonite with 20 mg L−1 Al3+ (from BOPAC) and 0.5 mg L−1 anionic polyelectrolyte resulted in the efficient reduction of the turbidity (4–6 NTU), the COD (158 mg L−1) and the extractable oil content (4 mg L−1) with efficiencies of 98%, 59%, and 85%, respectively. By applying organophilic bentonite in high concentration (500 mg L−1) with identical concentrations of BOPAC and anionic polyelectrolyte, significant color removal (5 times lower absorbance at λ = 400 nm) and 27% lower sediment volume were achieved.
Membrane filtration is an effective technique for separating micro- and nano-sized oil droplets from harmful oil-contaminated waters produced by numerous industrial activities. However, significant flux reduction discourages the extensive application of this technology; therefore, developing antifouling membranes is necessary. For this purpose, various titanium dioxide/carbon nanotube (TiO2/CNT) nanocomposites (containing 1, 2, and 5 wt.% multi-walled CNTs) were used for the modification of polyvinylidene fluoride (PVDF) ultrafilter (250 kDa) membrane surfaces. The effects of surface modifications were compared in relation to the flux, the filtration resistance, the flux recovery ratio, and the purification efficiency. TiO2/CNT2% composite modification reduced both irreversible and total filtration resistances the most during the filtration of 100 ppm oil emulsions. The fluxes were approximately 4–7 times higher compared to the unmodified PVDF membrane, depending on the used transmembrane pressure (510, 900, and 1340 L/m2h fluxes were measured at 0.1, 0.2, and 0.3 MPa pressures, respectively). Moreover, the flux recovery ratio (up to 68%) and the purification efficiency (95.1–99.8%) were also significantly higher because of the surface modification, and the beneficial effects were more dominant at higher transmembrane pressures. TiO2/CNT2% nanocomposites are promising to be applied to modify membranes used for oil–water separation and achieve outstanding flux, cleanability, and purification efficiency.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.