Electrical discharge machining (EDM) is a non-conventional process where complex and difficult-to-cut materials can be machined. Adhesive copper foil as an assisting electrode (AE) is used to cover the zirconia (ZrO 2 ) surface to start the primary spark between the tool electrode and workpiece. Kerosene is dissociated and produces a carbon layer on the workpiece surface when machining of the initial copper foil is completed. Thus machining continues although ZrO 2 is a non-conductive material. In this study, the EDM of ZrO 2 is investigated with graphite, copper and brass tool electrodes. Material removal rate (MRR) and surface characteristics are analysed. Experiments are performed by varying the parameters peak current and pulse-on time with different tool electrodes. From the experiments, MRR on ZrO 2 has been compared for three different tool electrodes. It is found that the graphite tool electrode performs the highest MRR for EDM of ZrO 2 . The least MRR is obtained by the brass tool electrode. However, better surface quality is observed with the copper tool electrode than EDM with brass or graphite electrodes. This investigation with varying machining parameters and different tool electrodes can be helpful in finding an effective use of the EDM process.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.