The aerodynamic module combines the three-dimensional nonlinear lifting surface theory approach, which provides the effective propagated incident velocity and angle of attack at the blade section separately, and a two-dimensional panel method for steady axisymmetric and non-symmetric flow has to be involved to obtain the 3D pressure and velocity distribution on the wind mill model blade. Wind mill and turbines have become an economically competitive form of efficiency and renewable work generation. In the abroad analytical studies, the wind turbine blades to be the target of technological improvements by the use of highly possible systematic , aerodynamic and design, material analysis, fabrication and testing. Wind energy is a peculiar form of reduced form of density source of power. To make wind power feasible, it is important to optimize the efficiency of converting wind energy into productivity source. Among the different aspects involved, rotor aerodynamics is a key determinant for achieving this goal. There is a tradeoff between thin airfoil and structural efficiency. Both of which have a strong impact on the cost of work generated. Hence the design and analysis process for optimum design requires determining the load factor, pressure and velocity impact and optimum thickness distribution by finding the effect of blade shape by varying thickness on the basis of both the aerodynamic output and the structural weight.
The flow angularity in a wind tunnel plays a major role in test section when testing models. The models are being tested at a mixture of flow velocity. Usually a subsonic wind tunnel is calibrated using a normal Pitot tube and supersonic wind tunnels with high efficiency probes. The calibration of a wind tunnel includes determining the Mach number range ad pressure range throughout the test section of the flow throughout the pattern of operating velocity. In the analysis it is noted that the sensitivities of the calibrating instruments are maximum when it is either cone or wedge shaped. When the wedge or cone angles are maximum, more accurate results are also obtained, but it’s not possible to have a maximum angle cone or wedge because of the detached wave and tunnel blockage factors. Hence in order to overcome this difficulties in measurement, a five probe flow analyzer has been designed. The five probe flow analyzer is used to determine the wind tunnel test section parameters like flow angularity, Pitot pressures, static pressures, wave angles, and the presence of test section noise. Over to these parameter, the stagnation states can also be determined using this analyzer. The proposed model is designed by getting optimum solutions from previous analysis and the existing data by considering all the aerodynamic and mechanical loading. This instrument designed is to be tested experimentally after carrying two and three dimensional computational analysis for Mach number ranging from 0.5 of 3. Also it is designed to fit successfully for 0.3m and 0.6m test section wind tunnel to obtain reasonably merging solution with theoretical and experimental results.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.