Recent studies have shown that infraorbital nerve constriction (IoNC)-induced mechanical allodynia has been attenuated by administration of highly purified 150-kDa Botulinum neurotoxin type A (BoNT/A). Here, we extend these studies to determine whether BoNT/A could attenuate IoNC-induced symptoms of thermal hyperalgesia. Instead of testing head withdrawal thresholds, a thermal operant assay was used to evaluate cortical processing of sensory input following IoNC. In this assay, a fasted rat's desire to obtain a food reward (sweetened condensed milk) is coupled to its ability to tolerate facial contact with a warm (45 °C) thermode. Bilateral IoNC decreased the ratio of thermode contact duration/event, which is an indicative of thermal hyperalgesia. BoNT/A injection intradermally in the area of infraorbital nerve (IoN) innervation 7 days after IoNC resulted in decreased number of facial contacts and increased the ratio of contact duration/event (measured at 14 days after IoNC). The BoNT/A (2-200 pg) effects were dose dependent and statistically significant at 100 and 200 pg (P < 0·05). Complete reversal of thermal hyperalgesia symptoms was obtained with a 200-pg dose, without affecting sham rat behaviour. Off-site (neck) injection of BoNT/A did not relieve thermal hyperalgesia, while co-injection of BoNT/A with a neutralising antibody in the area of IoN innervation prevented relief of thermal hyperalgesia. Neither IoNC nor BoNT/A injection affected operant assay parameters with a 24 °C thermode, indicating selectivity of thermal hyperalgesia measurements. These results strongly suggest that intradermal injection of BoNT/A in the area of IoN innervation alleviates IoNC-induced thermal hyperalgesia in an operant assay.

Resin coating materials have been used for composite resin or provisional restoration in order to prevent plaque accumulation on their surfaces. However, it is not clear whether the coating materials influence attachment of periodontal bacteria. Therefore, we investigated the effect of resin coating materials on the attachment of Porphyromonas gingivalis (Pg). The polymerized auto cure resin plates were coated with two resin coating materials. To estimate the Pg attachment, each plate was immersed in brain heart infusion medium containing Pg. The quantity of bacteria attached on each plate was evaluated by crystal violet quantification. Morphological change of Pg was recorded using scanning electron microscopy. Both coating groups presented significantly lower Pg attachment compared to the control. The Pg shapes on the plates with resin coating materials were similar to the non-treated control plates. The resin coating materials clearly prevent Pg attachment on the polymerized auto cure resin plate.