Articular cartilage has a low capacity for spontaneous repair. To promote the repair of this tissue, the transfer of autologous chondrocytes using a three-dimensional matrix appears promising. In this context, the aim of the present work was to investigate the potential use of autologous rabbit nasal chondrocytes (RNC) associated with an injectable self-setting cellulose-based hydrogel (Si-HPMC). Firstly, the influence of Si-HPMC on chondrocytic phenotype was investigated by real-time PCR for specific chondrocyte markers (type II collagen and aggrecan) and type I collagen. Thereafter, autologous RNC were amplified in vitro for 4 weeks before transplantation with Si-HPMC into a rabbit articular cartilage defect followed by analysis 6 weeks later. Implants were histologically characterized for the presence of sulfated GAG and type II collagen. Transcripts analysis indicated that dedifferentiated RNC recovered expression of the main chondrocytic markers after in vitro three-dimensional culture within Si-HPMC. Histological analysis of autologous RNC transplanted in an articular cartilage defect revealed the formation of repair tissue with a histological organization similar to that of healthy articular cartilage. In addition, immunohistological analysis of type II collagen suggested that the repair tissue was a hyaline-like cartilage. Si-HPMC hydrogel associated with nasal chondrocytes therefore appears a promising injectable tissue engineering device for the repair of articular cartilage.

Three-dimensional (3D) printing is well acknowledged to constitute an important technology in tissue engineering, largely due to the increasing global demand for organ replacement and tissue regeneration. In 3D bioprinting, which is a step ahead of 3D biomaterial printing, the ink employed is impregnated with cells, without compromising ink printability. This allows for immediate scaffold cellularization and generation of complex structures. The use of cell-laden inks or bio-inks provides the opportunity for enhanced cell differentiation for organ fabrication and regeneration. Recognizing the importance of such bio-inks, the current study comprehensively explores the state of the art of the utilization of bio-inks based on natural polymers (biopolymers), such as cellulose, agarose, alginate, decellularized matrix, in 3D bioprinting. Discussions regarding progress in bioprinting, techniques and approaches employed in the bioprinting of natural polymers, and limitations and prospects concerning future trends in human-scale tissue and organ fabrication are also presented.

International audienceThis paper describes the rheological properties of silated hydroxypropylmethylcellulose (HPMC-Si) used in biomaterials domain as a three-dimensional synthetic matrix for tissue engineering. The HPMC-Si is an HPMC grafted with 3-glycidoxypropyltrimethoxysilane (GPTMS). HPMC and HPMC-Si were studied. It is shown that although silanization reduces the hydrodynamic volume in dilute solution, it does not affect significantly the rheological behavior of the concentrated solutions. The HPMC-Si viscous solution (pH 12.8) cross-links by decreasing the pH using an acid buffer, since HPMC-Si solution transforms into an elastic state. The kinetics of cross-linking and final elastic properties is influenced by several parameters such as polymer concentration, pH and temperature. pH and temperature play an important role in the silanol condensation, mainly responsible for network formation. The study of the gelation process revealed the dependence of the final concentration of HPMC-Si hydrogel on cross-linking kinetics and viscoelastic properties. The percolation theory was applied to determine gel point and to discuss the dependence of storage (G') and loss (G'') moduli on frequency. Results showed that both G' and G'' exhibit a power-law behavior with an exponent (0.68) which extends over the entire frequency range. This method is the only one to characterize the time where a liquid viscous phase shifts to hydrogel with elastic properties. In this case it was about 23 min for a final pH of 7.4