The research goal was to investigate the hydraulic conductivity of compacted lime-softening sludge as a material to be applied to landfill liners. In doing so, the effect of compaction and moulding moisture content on the sludge hydraulic conductivity was assessed. An approximate polynomial k 10mean at hydraulic gradients ≥30 for degree of compaction (0.95-1.05) and moulding moisture content (28%-36%) was determined. The results of short-term tap water permeation tests revealed that all hydraulic conductivity values were less than 2.5•10-8 m/s. A lowest hydraulic conductivity of 6.5•10-9 m/s, as well as a corresponding moisture content of 31% were then established. The long-term hydraulic conductivity was measured with tap water, distilled water, NaOH and HCl solutions and municipal waste leachate. The factors of permeating liquids and permeation time significantly affected the initial hydraulic conductivity. The long-term hydraulic conductivity increased for NaOH and HCl solutions and decreased for tap and distilled water. A significant reduction of hydraulic conductivity was observed for leachate permeation. The investigated material met the requirements for the liner systems of inert landfill sites regardless of pH and the limit value for hazardous and non-hazardous waste landfills.
The objective of this study was to investigate the swelling potential of compacted lime-softening sludge for application in landfill liners. The study involved the assessment of the effect of compaction and moulding moisture content (30–40%), corresponding to the Proctor standard compaction test. One-dimensional oedometer swell tests were conducted using distilled water, tap water, and municipal landfill leachate, resulting in the determination of the expansion indices. Moreover, changes in the moisture content and dry density during the swelling process were investigated. The expansion index was significantly influenced by the initial moisture content and liquid chemistry. Subsequently, these factors also affected the sludge dry density decrease, and its moisture content increase, whereas the impact of the initial dry density on expansion was of low importance. An increase in the sludge moulding moisture content, limited swelling in all liquids used. The highest expansion, dry density, and moisture content changes due to swelling were identified for leachate at w < wopt. It should be underlined that the effect of liquid on the swelling potential faded away along with a further increase in the moisture content w > wopt. The novelty of the work lies in identifying a significant plunge of the expansion index at w ≈ wopt for the leachate swelling test. The lime-softening sludge non-swelling moisture content was defined as wnon ≈ (wopt + 4.0%) − (wopt + 4.5%). For practical engineering implications, the moisture content between (wopt + 2.0%) and (wopt + 4.0%) was provided for the most suitable sludge application in landfill liners.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.