No abstract

A rational approach for a photosystem II-based electrode assembly is described, integrating redox polymers with high surface area hierarchically structured electrodes.

Hydrogen is one of the most promising alternatives for fossil fuels. However, the power output of hydrogen/oxygen fuel cells is often restricted by mass transport limitations of the substrate. Here, we present a dual-gas breathing H2/air biofuel cell that overcomes these limitations. The cell is equipped with a hydrogen-oxidizing redox polymer/hydrogenase gas-breathing bioanode and an oxygen-reducing bilirubin oxidase gas-breathing biocathode (operated in a direct electron transfer regime). The bioanode consists of a two layer system with a redox polymer-based adhesion layer and an active, redox polymer/hydrogenase top layer. The redox polymers protect the biocatalyst from high potentials and oxygen damage. The bioanodes show remarkable current densities of up to 8 mA cm-2. A maximum power density of 3.6 mW cm-2 at 0.7 V and an open circuit voltage of up to 1.13 V were achieved in biofuel cell tests, representing outstanding values for a device that is based on a redox polymer-based hydrogenase bioanode.

We report a simple, facile, and safe route for preparation of cobalt–cobalt phosphide (Co/Co2P) nanoparticles and demonstrate their application as efficient low-cost catalysts for electrochemical water splitting. The catalyst achieves good performance in catalyzing both the cathode and anode half-cell water-splitting reactions in 1.0 M KOH and the hydrogen evolution reaction in an acidic electrolyte, 0.5 M H2SO4. For the oxygen evolution reaction in 1.0 M KOH, a current of 10 mA cm–2 was attained at 0.39 V overpotential on a glassy carbon electrode, while an overpotential of 0.19 V was attained at 50 mA cm–2 when the catalyst was supported on nickel foam.

This manuscript provides the first systematic characterization of the electrochemical properties of the high mobility n-type polymer poly{[N,N′-bis(2octyldodecyl)-naphthalene-1,4,5,8-bis (dicarboximide)-2,6-diyl]-alt-5,5′-(2,2′-bithiophene)} (P(NDI2OD-T2)) and its corresponding monomer 2,6-bis(2-bromothien-5-yl)naphthalene-1,4,5,8-tetracarboxylic-N,N′-bis(2-octyldodecyl) diimide (Br-NDI2OD-T2-Br) by cyclic voltammetry and in situ spectroelectrochemistry. Both monomer and polymer reveal a 2-fold reduction to the dianion via a radical anion species. The comparison between monomeric and polymeric species allows the explanation of the electrochemical behavior of P(NDI2OD-T2) according to redox polymers with localization of charges on the naphthalene bisimide unit. Measurements with electrolyte gated transistors suggest electron hopping transport according to mixed valence conductivity. In the last section of this paper we discuss a significant first cycle effect upon electrochemical reduction which had not been reported for ntype polymers before. The effect is even more pronounced for samples with controlled morphology, that is, high amounts of aggregation in the films. In agreement with solution experiments we attribute the appearance of the signal at −1.04 V (E 1/2 = −1.00 V) to the radical anion form of the solvated species.

No abstract

We report on the fabrication of bioanodes for H 2 oxidation based on [NiFeSe] hydrogenase. The enzyme was electrically wired by means of a specifically designed low-potential viologen-modified polymer, which delivers benchmark H 2 oxidizing currents even under deactivating conditions owing to efficient protection against O 2 combined with a viologen-induced reactivation of the O 2 inhibited enzyme. Moreover, the viologen-modified polymer allows for electrochemical co-deposition of polymer and biocatalyst and, by this, for control of the film thickness. Protection and reactivation of the enzyme was demonstrated in thick and thin reaction layers.

Solar-driven coupling of water oxidation with CO2 reduction sustains life on our planet and is of high priority in contemporary energy research. Here, we report a photoelectrochemical tandem device that performs photocatalytic reduction of CO2 to formate. We employ a semi-artificial design, which wires a W-dependent formate dehydrogenase (FDH) cathode to a photoanode containing the photosynthetic water oxidation enzyme, Photosystem II, via a synthetic dye with complementary light absorption. From a biological perspective, the system achieves a metabolically inaccessible pathway of light-driven CO2 fixation to formate. From a synthetic point of view, it represents a proof-of-principle system utilizing precious-metal-free catalysts for selective CO2-to-formate conversion using water as an electron donor. This hybrid platform demonstrates the translatability and versatility of coupling abiotic and biotic components to create challenging models for solar fuel and chemical synthesis.