Invar alloys are used for high‐precision applications due to their invariance of the coefficient of thermal expansion over a temperature range up to about 250 °C. The present study determines the mechanical and corrosive properties of Invar 36 (64 % Iron – 36 % Nickel) specimens produced by laser powder bed fusion. Tensile specimens were fabricated to investigate the mechanical properties. The influence of a horizontal and vertical building orientation is considered. An apparent mechanical anisotropy depending on the respective building is observed. Based on this, further tensile specimens were stored in a hydrochloric acid pickling solution, a sulphate buffer solution and a sodium chloride solution to analyse the corrosion behaviour. The findings after eight weeks in the individual media show that outsourcing the Invar 36 specimens in a sulphate buffer solution results in significant changes in the mechanical properties, especially fracture elongation.

Invar alloys possess the peculiarity of dimensional invariance, which is of importance for high precision applications, such as measurement instruments. As ductile face-centered cubic (fcc) material, it is adequately weldable and is nowadays readily available as powder feed stock for additive manufacturing processes. Single-phase fcc alloys are known to often be highly textured, when fabricated via laser powder-bed fusion. Within this study, the thermal expansion behavior was analyzed via true differential dilatometry and the directional Young’s moduli were determined via impulse excitation technique in the temperature range up to 850 °C. The coefficient of thermal expansion was found to be nearly independent of the analyzed orientations. However, Young’s moduli differed by 20 GPa, with the highest stiffness obtained for specimens orientated parallel to the x-axis of the machines’ coordinate system.