No abstract

Processing by injection is the technological process by that the thermoplastics material is injected, under pressure, in the cavity of a mould, where it cools down and solidifies. This process is the most common method for obtaining plastic materials. Injection moulding of thermoplastics has emerged as the premier vehicle for delivering high quality, value added commercial products. Continued global competitiveness has increased standards for product capability and quality while requiring reduced product development time and unit cost. Despite advanced design methods and new process technologies, it is becoming apparent that the injection moulding process is neither flexible nor robust. This paper presents a design process using CAD-CAM software applied to an injection mould for manufacturing a plastic component that is used in the automotive industry. The component was analyzed, measured and subjected to simulations that will certify the quality of the final product.

The bulk metallic glasses composites are a new class of bulk metallic glasses (BMGs), containing an amorphous metal matrix and reinforcing materials of metallic or ceramic nature in order to obtaining the desired combination of mechanical properties including strength, hardness, ductility and toughness. Composite materials of cylindrical form with the diameter of 10 mm and 5 mm in height were successfully prepared by hot-pressing of Zr - based glassy alloy powder and Fe - based nanocrystalline alloy powder in different volume fraction. The samples obtained were structural investigated by scanning electron microscopy and X-Ray diffraction and mechanically characterized by hardness and compression tests. It was found that increasing the volume ratio of the Fe-based nanocrystalline alloy up to a certain value leads to an increase in hardness and mechanical compressive strength.