Coal is the most abundant and readily combustible energy resource being used worldwide. However, its structural characteristic creates a perception that coal is only useful for producing energy via burning. Here we report a facile approach to synthesize tunable graphene quantum dots from various types of coal, and establish that the unique coal structure has an advantage over pure sp 2 -carbon allotropes for producing quantum dots. The crystalline carbon within the coal structure is easier to oxidatively displace than when pure sp 2 -carbon structures are used, resulting in nanometre-sized graphene quantum dots with amorphous carbon addends on the edges. The synthesized graphene quantum dots, produced in up to 20% isolated yield from coal, are soluble and fluorescent in aqueous solution, providing promise for applications in areas such as bioimaging, biomedicine, photovoltaics and optoelectronics, in addition to being inexpensive additives for structural composites.

Graphene and single-walled carbon nanotubes are carbon materials that exhibit excellent electrical conductivities and large specific surface areas. Theoretical work suggested that a covalently bonded graphene/single-walled carbon nanotube hybrid material would extend those properties to three dimensions, and be useful in energy storage and nanoelectronic technologies. Here we disclose a method to bond graphene and single-walled carbon nanotubes seamlessly during the growth stage. The hybrid material exhibits a surface area 42,000 m 2 g À 1 with ohmic contact from the vertically aligned single-walled carbon nanotubes to the graphene. Using aberration-corrected scanning transmission electron microscopy, we observed the covalent transformation of sp 2 carbon between the planar graphene and the single-walled carbon nanotubes at the atomic resolution level. These findings provide a new benchmark for understanding the three-dimensional graphene/ single-walled carbon nanotube-conjoined materials.

Ionic transport inside porous carbon electrodes underpins the storage of energy in supercapacitors and the rate at which they can charge and discharge, yet few studies have elucidated the materials properties that influence ion dynamics. Here we use in situ pulsed field gradient NMR spectroscopy to measure ionic diffusion in supercapacitors directly. We find that confinement in the nanoporous electrode structures decreases the effective self-diffusion coefficients of ions by over two orders of magnitude compared to neat electrolyte, and in-pore diffusion is modulated by changes in ion populations at the electrode-electrolyte interface during charging.Electrolyte concentration and carbon pore size distributions also affect in-pore diffusion and the movement of ions in and out of the nanopores. In light of our findings we propose that controlling the charging mechanism may allow the tuning of the energy and power performances of supercapacitors for a range of different applications.As renewable energy and green technologies such as electric vehicles become prevalent, we must develop new ways to store and release energy on a range of timescales. Rechargeable batteries are ideal for timescales of minutes or hours (electric cars, portable electronic devices, grid storage etc.), while supercapacitors are more promising for second or sub-second timescales and are increasingly being used for transport applications where rapid charging and discharging are required. The superior power handling and cycle lifetime of supercapacitors comes at the expense of energy density, with recent materials-driven research aiming to address this issue by fine-tuning the nanoporous structure of the carbon electrodes, 1,2 and by using ionic liquid electrolytes that are stable at higher voltages. 3,4 Both approaches have afforded some increases in energy density, though not without sacrificing power density. The delicate balance between energy and power density must be understood if supercapacitors are to be used in a wide range of applications.Fundamental studies based on spectroscopic, 5-14 and theoretical, 15-18 methods have recently revealed the complex nature of charging in supercapacitors. Prior to charging, the electrode pores contain a large number of electrolyte ions, 15,19,20 and as a result charge storage is generally more complex than simple counter-ion adsorption (counter-ions are defined as having charge opposite to the electrode in which they are located). [5][6][7]15 A range of different charging mechanisms can operate

A facile and cost-effective approach for the fabrication of a hierarchical nanocomposite material of graphene-wrapped MnO2 -graphene nanoribbons (GMG) is developed. The resulting composite has a high specific capacity and an excellent cycling stability owing to the synergistic combination of the electrically conductive graphene, graphene nanoribbons, and MnO2 .

A cost-effective and potentially industrially scalable, in situ functionalization procedure for preparation of soluble graphene nanoribbon (GNRs) from commercially available carbon nanotubes is presented. The physical characteristics of the functionalized product were determined using SEM, evolved gas analysis, X-ray diffraction, solid-state (13)C NMR, Raman spectroscopy, and GC-MS analytical techniques. A relatively high preservation of electrical properties in the bulk material was observed. Moreover, replacement of intercalated potassium with haloalkanes was obtained. While carbon nanotubes can be covalently functionalized, the conversion of the sp(2)-hybridized carbon atoms to sp(3)-hybridized atoms dramatically lowers their conductivity, but edge functionalized GNRs permit their heavy functionalization while leaving the basal planes intact.