Issues on 3-monochloropropane-diol-1,2-diol (MCPD) esters and glycidyl esters in refined oil have gained much attention when these heat-induced contaminants are associated with health implications. Oil that undergoes the frying process could influence the fates of 3-MCPD esters and glycidyl esters, especially with the addition of an anti-clouding agent. In this study, we investigated the effect of polyglycerol fatty acid esters (PGE) on the transients of 3-MCPD esters and glycidyl esters in palm olein (POo) during intermittent frying. Thermal resistance of POo fortified with PGE (0.1% to 0.4%) was assessed for 8 h of daily frying operations at 180 °C across five consecutive days. The addition of PGE decelerated the reduction of 3-MCPD esters and glycidyl esters with the progression of frying. The presence of these compounds coincided with the amount of oil taken up by the fried product. The inclusion of PGE in POo also induced higher augmentation of polar compound fractions, i.e., oxidised triacylglycerols (OxTAG) and polymerised triacylglycerols (PTAG), but gave comparable free fatty acid (FFA), p-anisidine value (AnV), total chloride and fatty acid composition (FAC) with control oil (POo). The results also showed that the presence of chloride in POo did not onset further formation of 3-MCPD esters and glycidyl esters throughout the frying period. As the behaviours of 3-MCPD esters and glycidyl esters were affected by PGE, only a sufficient amount should be added into POo to ensure oil clarity at a realistic period.

Commercial oil D 0.06±0.00 f 3.0±0.0 a 5.83±0.05 c 2.66±0.31 c 2.59±0.18 c 1.20±0.10 b 0.76±0.03 d Commercial oil E 0.20±0.00 b 2.3±0.0 c 5.82±0.06 c 3.30±0.13 b 0.84±0.02 f 0.38±0.00 d 2.85±0.02 b Mean of triplicate analysis±SD Values within a column with different superscript letters are significantly different (p < 0.05)

This study was conducted to investigate on the effect of different sampling regions of palmrefined oils and fats on the 2-and 3-monochloropropanediol fatty acid esters (MCPDE) and glycidol fatty acid esters (GE) levels. The American Oil Chemists' Society (AOCS) Official Method Cd 29a-13 on the determination of MCPDE and GE in edible oils and fats by acid transesterification was successfully verified and optimised, with slight modification using 7890A Agilent GC system equipped with 5975C quadrupole detector. The determined limits of detection (LOD) for MCPDE were 0.02 mg kg⁻¹ and 0.05 mg kg⁻¹ for GE. The method performance has showed good recovery between 80% and 120% for all pertinent compounds with seven replicates assayed in three separate days. Round robin test with two European laboratories, i.e. Eurofins and SGS, has shown compliance results with those of the present study. Among the sampling regions, only one refinery located in the central region of Malaysia showed a significant increment of the MCPDE and GE levels after refining process.The GE level averaging at 2.5 mg kg⁻¹ was slightly higher than that of 3-MCPDE averaging at 1.3 mg kg⁻¹. Both esters were preferentially partitioned into the liquid phase rather than the solid phase after fractionation. However, the overall results exhibited no direct correlation between the esters content and the different sampling locations of the palm oil products in Malaysia. Analysis of total chlorine content also displayed significant variations between sampling locations which clearly show its effect on the chlorine content in the CPO samples.

No abstract