No abstract

During the past thirty years, there has been a steady growth in the size and number of ships that use the Strait of Istanbul (Bosporus), which is one of the most difficult, crowded, and potentially dangerous waterways in the world. There have been over two hundred accidents over the past decade resulting in loss of life and serious damage to the environment. Many of the proposed export routes for forthcoming production from the Caspian sea region pass westwards through the Black Sea and the Bosporus en-route to the Mediterranean Sea and world markets. The risks and dangers associated with tanker navigation, maritime accidents and environmental catastrophe are aggravated with the increase in the density of traffic, tanker size and cargo capacity, as well as the nature of the cargo. In order to ease the problem, a Traffic Separation Scheme (TSS) was established and approved by IMO in 1994. This scheme has drastically reduced the number of collisions. However, one-way or two-way suspension of traffic in the Bosporus is inevitable for ships that cannot comply with the TSS because of their type, size or poor manoeuvring characteristics. The selection of size criteria to comply with the TSS has been a matter of discussion. This paper presents the results of a real-time simulation study investigating the manoeuvring performance of large tankers in the Bosporus. The study was conducted with a simulator capable of subjecting a given hull form to any combination of environmental conditions, i.e. wind, current and wave drift forces. The results indicate that, when realistic environmental conditions are taken into account, the size of ships that can navigate safely in compliance with the traffic separation lanes is limited.

Estimation of ship self-propulsion is important for the selection of the propulsion system and the main engine so that the ship can move forward with the required speed. Resistance characteristics of the vessel or the open-water performance of a propeller only are not usually enough to assess the working conditions of the ship. Both in numerical simulations and in experiments; there is a need to treat the propulsion system and the hull as a whole for a better estimation of the self-propulsion parameters. In this study, the self-propulsion points of one submarine (DARPA Suboff) and two surface piercing vessels (KCS and DTC) were obtained with methods based on computational fluid dynamics (CFD) approach. The self-propulsion points were also calculated by a classical engineering approach that makes use of the empirical relations that may be found in the literature. The results were evaluated with respect to the experiments and numerical results generated by other researchers in this field. It was found that the self-propulsion points of traditional ship forms can be very closely approximated with a classical engineering approach, given the basic geometric and the hydrostatic properties of the hull and the propeller.

No abstract

The propeller performance has been investigated using a benchmark Duisburg Test Case ship with RANSE. First, the hydrodynamic characteristics of propeller in case of open water have been analyzed by a commercial CFD program and the results are compared with those of experimental data. Later, the flow around the bare hull has been solved and the frictional resistance value and form factor of the ship have been obtained and compared with those of ITTC57 formulation and experimental results for validation. The free surface effect has been ignored. A good agreement has been obtained between the results of RANSE and experiments at both stages. Then the ship -propeller interaction problem was solved by RANSE and the differences in thrust, torque and efficiency of propeller as compared with the open-water numerical results have been discussed.