Flow of suspensions in porous media with particle capture and detachment under alternate flow rates is discussed. The mathematical model contains the maximum retention concentration function of flow velocity that governs the particle release and is used instead of equation for particle detachment kinetics from the classical filtration model. An analytical model for suspension injection with alternate rates was derived, and a coreflood by suspension with alternate rates was carried out. The modelling and laboratory data are in a good agreement, which validates the modified particle detachment model with the maximum retention function.

Permeability decline during corefloods with varying water composition, especially with low-salinity water, has been widely reported in the literature. This effect can provide a relatively simple method for mobility control during waterflooding.In this work, new basic equations for waterflooding with salinity variations causing the detachment of fine particles, their migration, and their straining are derived. The maximum concentration of attached fine particles as a function of water salinity and saturation is used to model the fines detachment. In large-scale approximation, the equivalence between the model for two-phase flow with fines migration and the adsorption-free polymer-flood model is established, which allows applying a commercial polymer flood simulator for modeling the waterflood with induced fines migration. The modeling showed that the permeability decline in the water-swept zone, caused by the alteration of the injected water composition and induced fines migration, may be able to improve waterflood performance by delaying water breakthrough, increasing sweep efficiency, and reducing the water cut, thus providing a relatively simple method for mobility control during waterflooding.

No abstract

No abstract

No abstract

No abstract

Permeability decline during corefloods with varying water composition, especially with low salinity water, has been widely reported in the literature. It has often been explained by the lifting, migration and subsequent plugging of pores by fine particles, which has been observed in numerous core flood tests with altered water composition. This effect can be considered to provide a relatively simple method for mobility control during waterflooding. In previous research, the Dietz model for waterflooding in a layer-cake reservoir with a constant injection and production rate was combined with a particle detachment model to investigate the effect of fines migration and induced permeability decline on reservoir sweep efficiency. In this work, the analytical model was extended to waterflooding with a given pressure drop between injection and production wells. The modelling showed that permeability decline in the water swept zone, caused by the alteration of the injected water composition and induced fines migration, may be able to improve waterflood performance by delaying water breakthrough and reducing the water cut at producing wells.

No abstract