The influence of high strain-rate loading on the flexural response of typical light-frame wood construction has been investigated. A total of 30 stud grade 38 mm × 140 mm × 2440 mm (2== × 6== × 8=) spruce-pine-fir (S-P-F) lumber specimens were tested within a range of low and high strain-rates between 6 × 10 −6 s −1 and 0.4 s −1 . A single-degree-of-freedom iterative solution procedure was used to compute the high strain-rate modulus of rupture (MOR) and modulus of elasticity (MOE). The MOR was statistically enhanced by high strain-rates, while the MOE and strain at rupture were not. Since equilibrium of the dynamic stress-strain relationship requires that one or both of the MOE and strain at rupture must be sensitive to strain-rate effects, the lack of observed rate enhancement on these material properties was attributed to large scatter within a small sample set. Based on the results, material dynamic increase factors and a stress-strain relationship suitable for blast resistant design of timber structures were also proposed.Résumé : L'influence d'un chargement très rapide sur la réponse en flexion d'une construction typique à ossature de bois a été étudiée. Un total de 30 échantillons de catégorie colombage de 38 mm × 140 mm × 2440 mm (2== × 6== × 8=) en épinette -pin -sapin (E-P-S) a été mis à l'épreuve sous diverses vitesses, basses et élevées, situées entre 6 × 10 −6 s −1 à 0,4 s −1 . Le MOR (moment de résistance) et le MOE (module d'élasticité) sous une vitesse de chargement élevée ont été calculés selon une procédure itérative à un seul degré de liberté. Le MOR a été statistiquement accru par les vitesses de chargement élevées alors que le MOE et la contrainte à la rupture ne l'ont pas été. Puisque l'équilibre de la relation tension-contrainte dynamique exige que le MOE et-ou la contrainte à la rupture soient sensibles aux effets de la vitesse de chargement, le manque d'observation d'un accroissement de la vitesse sur ces propriétés de matériaux a été attribué à une grande dispersion dans un petit ensemble d'échantillons. En se basant sur les résultats, des facteurs d'augmentation du rapport résistance dynamique/résistance statique et une relation tension-déformation adéquate pour la conception résistante aux vitesses de chargement rapides pour les structures à ossature de bois sont proposés. [Traduit par la Rédaction] Mots-clés : explosion, vitesse de déformation élevée, facteur d'augmentation du rapport résistance dynamique/résistance statique, module de rupture, module d'élasticité, E-P-S, bois d'oeuvre, bois, montant, tube à chocs.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.