Organic aerosol (OA) particles affect climate forcing and human health, but their sources and evolution remain poorly characterized. We present a unifying model framework describing the atmospheric evolution of OA that is constrained by high-time-resolution measurements of its composition, volatility, and oxidation state. OA and OA precursor gases evolve by becoming increasingly oxidized, less volatile, and more hygroscopic, leading to the formation of oxygenated organic aerosol (OOA), with concentrations comparable to those of sulfate aerosol throughout the Northern Hemisphere. Our model framework captures the dynamic aging behavior observed in both the atmosphere and laboratory: It can serve as a basis for improving parameterizations in regional and global models.

A recently developed method to rapidly quantify the elemental composition of bulk organic aerosols (OA) using a high-resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS) is improved and applied to ambient measurements. Atomic oxygen-to-carbon (O/C) ratios characterize the oxidation state of OA, and O/C from ambient urban OA ranges from 0.2 to 0.8 with a diurnal cycle that decreases with primary emissions and increases because of photochemical processing and secondary OA (SOA) production. Regional O/C approaches approximately 0.9. The hydrogen-to-carbon (H/C, 1.4--1.9) urban diurnal profile increases with primary OA (POA) as does the nitrogen-to-carbon (N/C, approximately 0.02). Ambient organic-mass-to-organic-carbon ratios (OM/OC) are directly quantified and correlate well with O/C (R2 = 0.997) for ambient OA because of low N/C. Ambient O/C and OM/OC have values consistent with those recently reported from other techniques. Positive matrix factorization applied to ambient OA identifies factors with distinct O/C and OM/OC trends. The highest O/C and OM/OC (1.0 and 2.5, respectively) are observed for aged ambient oxygenated OA, significantly exceeding values for traditional chamber SOA,while laboratory-produced primary biomass burning OA (BBOA) is similar to ambient BBOA, O/C of 0.3--0.4. Hydrocarbon-like OA (HOA), a surrogate for urban combustion POA, has the lowest O/C (0.06--0.10), similar to vehicle exhaust. An approximation for predicting O/C from unit mass resolution data is also presented.

The development of a new high-resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS) is reported. The high-resolution capabilities of this instrument allow the direct separation of most ions from inorganic and organic species at the same nominal m/z, the quantification of several types of organic fragments (CxHy, CxHyOz, CxHyNp, CxHyOzNp), and the direct identification of organic nitrogen and organosulfur content. This real-time instrument is field-deployable, and its high time resolution (0.5 Hz has been demonstrated) makes it well-suited for studies in which time resolution is critical, such as aircraft studies. The instrument has two ion optical modes: a single-reflection configuration offers higher sensitivity and lower resolving power (up to approximately 2100 at m/z 200), and a two-reflectron configuration yields higher resolving power (up to approximately 4300 at m/z 200) with lower sensitivity. The instrument also allows the determination of the size distributions of all ions. One-minute detection limits for submicrometer aerosol are <0.04 microg m(-3) for all species in the high-sensitivity mode and <0.4 microg m(-3) in the high-resolution mode. Examples of ambient aerosol data are presented from the SOAR-1 study in Riverside, CA, in which the spectra of ambient organic species are dominated by CxHy and CxHyOz fragments, and different organic and inorganic fragments at the same nominal m/z show different size distributions. Data are also presented from the MIRAGE C-130 aircraft study near Mexico City, showing high correlation with independent measurements of surrogate aerosol mass concentration.

The application of mass spectrometric techniques to the real-time measurement and characterization of aerosols represents a significant advance in the field of atmospheric science. This review focuses on the aerosol mass spectrometer (AMS), an instrument designed and developed at Aerodyne Research, Inc. (ARI) that is the most widely used thermal vaporization AMS. The AMS uses aerodynamic lens inlet technology together with thermal vaporization and electron-impact mass spectrometry to measure the real-time non-refractory (NR) chemical speciation and mass loading as a function of particle size of fine aerosol particles with aerodynamic diameters between approximately 50 and 1,000 nm. The original AMS utilizes a quadrupole mass spectrometer (Q) with electron impact (EI) ionization and produces ensemble average data of particle properties. Later versions employ time-of-flight (ToF) mass spectrometers and can produce full mass spectral data for single particles. This manuscript presents a detailed discussion of the strengths and limitations of the AMS measurement approach and reviews how the measurements are used to characterize particle properties. Results from selected laboratory experiments and field measurement campaigns are also presented to highlight the different applications of this instrument. Recent instrumental developments, such as the incorporation of softer ionization techniques (vacuum ultraviolet (VUV) photo-ionization, Li+ ion, and electron attachment) and high-resolution ToF mass spectrometers, that yield more detailed information about the organic aerosol component are also described.

Project Description and Overview: Objectives: Determining the overall impact of atmospheric aerosols on radiative balance requires knowledge of the relative amounts of scattering and absorbing aerosols, their distributions, and their chemical and optical properties. This proposal was a continuation of measurements of aerosol scattering and absorption begun in Mexico City in 2003 in collaboration with MCMA 2003 and continuing in the Atmospheric Science Program field study, Megacity Aerosol Experiment-Mexico City, (MAX-Mex) during March of 2006 aimed at determining the variability of aerosol optical properties. A suite of instrumentation was deployed in MAX-Mex at site TO, located in the northern part of the Mexico City Metropolitan Area, (MCMA), for the characterization of the aerosol optical properties in the field. Measurements were made of the following aerosol properties: (1) aerosol absorption as a function of wavelength, measured at two minute intervals with a 7-wavelength Aethalometer (2) aerosol scattering as a function of wavelength, measured at one minute intervals with a 3-wavelength nephelometer; 3) aerosol scattering as a function of relative humidity (RH), measured at one minute intervals with 2 single-wavelength nephelometers operated under dry (10% RH) and wet (80% RH) conditions; and 4) collection of size-fractionated aerosol samples on quartz fiber filters at 12 hour intervals (day/night) for further laboratory characterization. Aerosol filter samples were also collected at site Tl (located north of MCMA) for comparison with those collected in the city center. Preliminary results from in situ measurements have indicated an enhanced UV absorption in the afternoon over that expected from black carbon (BC) aerosols alone. These results are directly applicable to both modeling of aerosol radiative forcing and satellite optical depth retrieval algorithms. Both of these applications assume that the aerosol absorption is due only to BC with a wavelength dependence of A, " whereas results obtained in MAX-Mex show that the aerosol wavelength exponent varies over Mexico City from-0.7 to-1.5. All of the data collected in the field from the measurement sets 1-3 have been made available to the ASP community via the MILAGRO data site housed at NCAR. The laboratory characterization of aerosol samples collected in the ASP MAX-Mex field study compared results from Mexico City to samples collected at other sites, including Chicago, Little Rock, and Mt. Bachelor, OR. The project focused on obtaining complete spectral characterization of aerosols-especially their absorption characteristics as they relate to basic chemical functional groups. Particular attention was given to organics and from biogenic derived organic compounds. This included determinations of the UV-Visible-NIR characteristics of the aerosol absorption as reported as Angstrom Absorption Exponents. Correlation of these results with IR band observations of carboxylic acid, and carboxylate groups were conducted, along with past correlations with carbon...

We present a new instrument, the Aerosol Chemical SpeciationMonitor (ACSM), which routinely characterizes and monitors the mass and chemical composition of non-refractory submicron particulate matter in real time. Under ambient conditions, mass concentrations of particulate organics, sulfate, nitrate, ammonium, and chloride are obtained with a detection limit <0.2 µg/m 3 for 30 min of signal averaging. The ACSM is built upon the same technology as the widely used Aerodyne Aerosol Mass Spectrometer (AMS), in which an aerodynamic particle focusing lens is combined with high vacuum thermal particle vaporization, electron impact ionization, and mass spectrometry. Modifications in the ACSM design, however, allow it to be smaller, lower cost, and simpler to operate than the AMS. The ACSM is also capable of routine stable operation for long periods of time (months). Results from a field measurement campaign in Queens, NY where the ACSM operated unattended and continuously for 8 weeks, are presented. ACSM data is analyzed with the same well-developed techniques that are used for the AMS. Trends in the ACSM mass concentrations observed during the Queens, NY study compare well with those from co-located instruments. Positive Matrix Factorization (PMF) of the ACSM organic aerosol spectra extracts two components: hydrocarbon-like organic aerosol (HOA) and oxygenated organic aerosol (OOA). The mass spectra and time trends of both

Abstract. High molecular weight (300-650 Da) naturally charged negative ions have previously been observed at a boreal forest site in Hyytiälä, Finland. The long-term measurements conducted in this work showed that these ions are observed practically every night between spring and autumn in Hyytiälä. The ambient mass spectral patterns could be reproduced in striking detail during additional measurements of α-pinene (C 10 H 16 ) oxidation at low-OH conditions in the Jülich Plant Atmosphere Chamber (JPAC). The ions were identified as clusters of the nitrate ion (NO − 3 ) and α-pinene oxidation products reaching oxygen to carbon ratios of 0.7-1.3, while retaining most of the initial ten carbon atoms. Attributing the ions to clusters instead of single molecules was based on additional observations of the same extremely oxidized organics in clusters with HSO

The Soot Particle Aerosol Mass Spectrometer (SP-AMS) was developed to measure the chemical and physical properties of particles containing refractory black carbon (rBC). The SP-AMS is an Aerodyne Aerosol Mass Spectrometer (AMS) equipped with an intracavity laser vaporizer (1064 nm) based on the Single ParticleSoot Photometer (SP2) design, in addition to the resistively heated, tungsten vaporizer used in a standard AMS. The SP-AMS can be operated with the laser vaporizer alone, with both the laser and tungsten vaporizers, or with the tungsten vaporizer alone. When operating with only the laser vaporizer, the SP-AMS is selectively sensitive to laser-light absorbing particles, such as ambient rBCcontaining particles as well as metal nanoparticles, and measures both the refractory and nonrefractory components. When operated with both vaporizers and modulating the laser on and off, the instrument measures the refractory components of absorbing particles and the nonrefractory particulate matter of all sampled particles. The SP-AMS design, mass spectral interpretation, calibration, and sensitivity are described. Instrument calibrations yield a sensitivity of greater than 140 carbon ions detected per picogram of rBC mass sampled, a 3σ detection limit of less than 0.1 µg·m −3 for 60 s averaging, and a mass-specific ionization efficiency relative to particulate nitrate of 0.2 ± 0.1. Sensitivities were found to vary depending upon laser-particle beam overlap. The utility of the instrument to characterize ambient rBC aerosol is demonstrated.