Surface rupture in the 2019 Ridgecrest, California, earthquake sequence occurred along two orthogonal cross faults and includes dominantly left-lateral and northeast-striking rupture in the Mw 6.4 foreshock and dominantly right-lateral and northwest-striking rupture in the Mw 7.1 mainshock. We present >650 field-based, surface-displacement observations for these ruptures and synthesize our results into cumulative along-strike displacement distributions. Using these data, we calculate displacement gradients and compare our results with historical strike-slip ruptures in the eastern California shear zone. For the Mw 6.4 rupture, we report 96 displacements measured along 18 km of northeast-striking rupture. Cumulative displacement curves for the rupture yield a mean left-lateral displacement of 0.3–0.5 m and maximum of 0.7–1.6 m. Net mean vertical displacement based on the difference of down-to-the-west (DTW) and down-to-the-east (DTE) displacement curves is close to zero (0.02 m DTW). The Mw 6.4 displacement distribution shows that the majority of displacement occurred southwest of the intersection with the Mw 7.1 rupture. The Mw 7.1 rupture is northwest-striking and 50 km long based on 576 field measurements. Displacement curves indicate a mean right-lateral displacement of 1.2–1.7 m and a maximum of 4.3–7.0 m. Net vertical displacement in the rupture averages 0.3 m DTW. The Mw 7.1 displacement distributions demonstrate that maximum displacement occurred along a 12-km-long portion of the fault near the Mw 7.1 epicenter, releasing 66% of the geologically based seismic moment along 24% of the total rupture length. Using our displacement distributions, we calculate kilometer-scale displacement gradients for the Mw 7.1 rupture. The steepest gradients (∼1–3 m/km) flank the 12-km-long region of maximum displacement. In contrast, gradients for the 1992 Mw 7.3 Landers and 1999 Mw 7.1 Hector Mine earthquakes are <0.6 m/km. Our displacement distributions are important for understanding the influence of cross-fault rupture on Mw 6.4 and 7.1 rupture length and displacement and will facilitate comparisons with distributions generated remotely and at broader scales.
The Mw 6.4 and Mw 7.1 Ridgecrest earthquake sequence occurred on 4 and 5 July 2019 within the eastern California shear zone of southern California. Both events produced extensive surface faulting and ground deformation within Indian Wells Valley and Searles Valley. In the weeks following the earthquakes, more than six dozen scientists from government, academia, and the private sector carefully documented the surface faulting and ground-deformation features. As of December 2019, we have compiled a total of more than 6000 ground observations; approximately 1500 of these simply note the presence or absence of fault rupture or ground failure, but the remainder include detailed descriptions and other documentation, including tens of thousands of photographs. More than 1100 of these observations also include quantitative field measurements of displacement sense and magnitude. These field observations were supplemented by mapping of fault rupture and ground-deformation features directly in the field as well as by interpreting the location and extent of surface faulting and ground deformation from optical imagery and geodetic image products. We identified greater than 68 km of fault rupture produced by both earthquakes as well as numerous sites of ground deformation resulting from liquefaction or slope failure. These observations comprise a dataset that is fundamental to understanding the processes that controlled this earthquake sequence and for improving earthquake hazard estimates in the region. This article documents the types of data collected during postearthquake field investigations, the compilation effort, and the digital data products resulting from these efforts.
The M 6.5 Monte Cristo Range earthquake that occurred in the central Walker Lane on 15 May 2020 was the largest earthquake in Nevada in 66 yr and resulted in a multidisciplinary scientific field response. The earthquake was the result of left-lateral slip along largely unmapped parts of the Candelaria fault, one of a series of east–northeast-striking faults that comprise the Mina deflection, a major right step in the north–northwest structural grain of the central Walker Lane. We describe the characteristics of the surface rupture and document distinct differences in the style and orientation of fractures produced along the 28 km long rupture zone. Along the western part of the rupture, left-lateral and extensional displacements occurred along northeasterly and north-striking planes that splay off the eastern termination of the mapped Candelaria fault. To the east, extensional and right-lateral displacements occurred along predominantly north-striking planes that project toward well-defined Quaternary and bedrock faults. Although, the largest left-lateral displacement observed was ∼20 cm, the majority of displacements were <5 cm and were distributed across broad zones up to 800 m wide, which are not likely to be preserved in the geologic record. The complex pattern of surface rupture is consistent with a network of faults defined in the shallow subsurface by aftershock seismicity and suggests that slip partitioning between east-striking left-lateral faults and north to northwest-striking right-lateral faults plays an important role in accommodating northwest-directed transtension in the central Walker Lane.
The M w 6.0 South Napa earthquake of 24 August 2014 caused slip on several active fault strands within the West Napa Fault Zone (WNFZ). Field mapping identified 12.5 km of surface rupture. These field observations, near-field geodesy and space geodesy, together provide evidence for more than~30 km of surface deformation with a relatively complex distribution across a number of subparallel lineaments. Along ã 7 km section north of the epicenter, the surface rupture is confined to a single trace that cuts alluvial deposits, reoccupying a low-slope scarp. The rupture continued northward onto at least four other traces through subparallel ridges and valleys. Postseismic slip exceeded coseismic slip along much of the southern part of the main rupture trace with total slip 1 year postevent approaching 0.5 m at locations where only a few centimeters were measured the day of the earthquake. Analysis of airborne interferometric synthetic aperture radar data provides slip distributions along fault traces, indicates connectivity and extent of secondary traces, and confirms that postseismic slip only occurred on the main trace of the fault, perhaps indicating secondary structures ruptured as coseismic triggered slip. Previous mapping identified the WNFZ as a zone of distributed faulting, and this was generally borne out by the complex 2014 rupture pattern. Implications for hazard analysis in similar settings include the need to consider the possibility of complex surface rupture in areas of complex topography, especially where multiple potentially Quaternary-active fault strands can be mapped.
The A.D. 2014 M6.0 South Napa earthquake, despite its moderate magnitude, caused significant damage to the Napa Valley in northern California (USA). Surface rupture occurred along several mapped and unmapped faults. Field observations following the earthquake indicated that the magnitude of postseismic surface slip was likely to approach or exceed the maximum coseismic surface slip and as such presented ongoing hazard to infrastructure. Using a laser scanner, we monitored postseismic deformation in three dimensions through time along 0.5 km of the main surface rupture. A key component of this study is the demonstration of proper alignment of repeat surveys using point cloud-based methods that minimize error imposed by both local survey errors and global navigation satellite system georeferencing errors. Using solid modeling of natural and cultural features, we quantify dextral postseismic displacement at several hundred points near the main fault trace. We also quantify total dextral displacement of initially straight cultural features. Total dextral displacement from both coseismic displacement and the first 2.5 d of postseismic displacement ranges from 0.22 to 0.29 m. This range increased to 0.33-0.42 m at 59 d post-earthquake. Furthermore, we estimate up to 0.15 m of vertical deformation during the first 2.5 d post-earthquake, which then increased by ~0.02 m at 59 d post-earthquake. This vertical deformation is not expressed as a distinct step or scarp at the fault trace but rather as a broad up-to-the-west zone of increasing elevation change spanning the fault trace over several tens of meters, challenging common notions about fault scarp development in strike-slip systems. Integrating these analyses provides three-dimensional mapping of surface deformation and identifies spatial variability in slip along the main fault trace that we attribute to distributed slip via subtle block rotation. These results indicate the benefits of laser scanner surveys along active faults and demonstrate that fine-scale variability in fault slip has been missed by traditional earthquake response methods.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.