The paper provides an overview of ways to increase the strength of polymer products obtained by fused filament fabrication (FFF) technology. An algorithm for calculating the spiral toolpaths for the material deposition using multi-axis printing is proposed. The design of the five-axis device for spiral-shaped deposition of the material is shown. The description of the proposed printing method is given. The results of comparative three-point bend and compression tests are presented. The standard samples obtained in the usual way by FFF technology, as well as samples with 2, 4, 6, 8 and 10 reinforcing layers obtained by spiral deposition of the material were investigated. The description of the tests is given, the dependences of the strength of the products on the number of reinforcing layers are obtained. Conclusions about the influence of the layer deposition method on the strength of the products are formulated.
310Machined surfaces of very high quality are required in honing the most important and most precise machine parts (for example, cylinder linings in internal-combustion engines for cars, trucks, and tractors), whose operational reliability is a primary concern in competitive markets.We know that the formation of even one deep scratch on the cylinder surface requires additional finishing (honing by bars with micropowder or lapping), with considerable loss of production time.Such scratches are due to the considerable size variation of the cutting grains that is permitted by the standard regarding the manufacture of diamond and abrasive honing bars. As a rule, the time required for the elimination of such scratches is up to 30% of the total machining time. Therefore, there is a pressing need to reduce the likelihood that large cutting grains will form part of the abrasive tool.The standard size distribution of diamond and abrasive grains in the tool does not permit the elimination of such defects in machining important parts (such as the linings of hydraulic cylinders in heavy-duty mechanisms within excavators, bulldozers, cranes, and other transport systems).One promising approach is to use a new single-component abrasive tool based on white corundum [1]. In the manufacture of this tool, boron-carbide powder must be added to white-electrocorundum abrasive powder (10-20 wt % boron carbide). Then a compressive shock wave is passed through the powder mixture, with subsequent high-temperature sintering in an electrovacuum furnace.When the shock wave passes through the powder mixture, the particles of each component are crushed.The size distribution of the white-electrocorundum and boron-carbide grains will be different.However, under the action of the impact force, the electrocorundum grains briefly move at enormous speed toward the boron-carbide grains (whose hardness is 37-43 GPa, as against 20-24 GPa for the electrocorundum) and are further crushed, which considerably changes their size distribution, since additional pores are formed in the high-temperature sintering of boron-carbide powder.After honing the 40 ï steel parts (the cylinder linings of A-type motors and hydraulic cylinders) by the new abrasive tool, the following results are obtained: the number of surface scratches is reduced to 0.1% (in other words, practically to zero); and the stable mean surface roughness of the machined part is Ra = 0.14-0.2 µ m, which is 2.4-3.2 times less than the value after machining with a diamond tool.
CONCLUSIONSThe action of a compressive shock wave on whiteelectrocorundum grains or on boron-carbide grains is insufficient to permit the use of these powders individually for abrasive tools in finishing. However, the application of a fast compressive shock wave to a mixture of white-electrocorundum and boron-carbide grains changes the size distribution of the grains at the working surface so that the machined surfaces obtained exhibit high performance. REFERENCES 1. Russian Patent 2293013.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.