The predictions of gyrokinetic and gyrofluid simulations of ion-temperature-gradient (ITG) instability and turbulence in tokamak plasmas as well as some tokamak plasma thermal transport models, which have been widely used for predicting the performance of the proposed ITER tokamak, are compared. These comparisons provide information on effects of differences in the physics content of the various models and on the fusion-relevant figures of merit of plasma performance predicted by the models. Many of the comparisons are undertaken for a simplified plasma model and geometry which is an idealization of the plasma conditions and geometry in a DIII-D H-mode experiment. Most of the models show good agreements in their predictions and assumptions for the linear growth rates and frequencies. There are some differences associated with different equilibria. However, there are significant differences in the transport levels between the models. The causes of some of the differences are examined in some detail, with particular attention to numerical convergence in the turbulence simulations (with respect to simulation mesh size, system size and, for particle-based simulations, the particle number). The implications for predictions of fusion plasma performance are also discussed.

A fixed combination of theory-based transport models, called the Multi-Mode Model, is used in the BALDUR [C. E. Singer et al., Comput. Phys. Commun. 49, 275 (1988)] transport simulation code to predict the temperature and density profiles in tokamaks. The choice of the Multi-Mode Model has been guided by the philosophy of using the best transport theories available for the various modes of turbulence that dominate in different parts of the plasma. The Multi-Mode model has been found to provide a better match to temperature and density profiles than any of the other theory-based models currently available. A description and partial derivation of the Multi-Mode Model is presented, together with three new examples of simulations of the Tokamak Fusion Test Reactor (TFTR) [K. M. McGuire et al., Phys. Plasmas 2, 2176 (1995)]. The first simulation shows the strong effect of recycling on the ion temperature profile in TFTR supershot simulations. The second simulation explores the effect of a plasma current ramp—where the plasma energy content changes slowly on the energy confinement time scale. The third simulation shows that the Multi-Mode Model reproduces the experimentally measured profiles when tritium is used as the hydrogenic isotope in L-mode (low confinement mode) plasmas.

Localized current injection near the outboard midplane is used to form 0.1 MA plasma discharges with no induction supplied from a central solenoid in the ultra-low aspect ratio Pegasus Toroidal Experiment. The discharges are initiated by driving open-field-line currents that perturb the vacuum magnetic field such that the magnetic topology transitions to a tokamak-like configuration. The plasma is subsequently driven via helicity injection from the edge current sources and poloidal field induction. Intermittent n = 1 MHD activity is observed during periods of strong edge current drive and each event leads to a rapid inward expansion of the plasma volume and a drop in the plasma inductance. The plasmas are sufficiently turbulent such that the equilibrium approaches the lowest energy state described by Taylor relaxation theory. In agreement with that theory, the maximum I p scales with (I TF I inj/w)1/2, where I TF is the toroidal field rod current, I inj is the injected edge current and w is the radial width of the average poloidal magnetic flux in the driven open flux region.

Startup of a 0.1 MA tokamak plasma is demonstrated on the ultralow aspect ratio Pegasus Toroidal Experiment using three localized, high-current density sources mounted near the outboard midplane. The injected open field current relaxes via helicity-conserving magnetic turbulence into a tokamaklike magnetic topology where the maximum sustained plasma current is determined by helicity balance and the requirements for magnetic relaxation.

The mission of the National Spherical Torus Experiment (NSTX) is the demonstration of the physics basis required to extrapolate to the next steps for the spherical torus (ST), such as a plasma facing component test facility (NHTX) or an ST based component test facility (ST-CTF), and to support ITER. Key issues for the ST are transport, and steady state high β operation. To better understand electron transport, a new high-k scattering diagnostic was used extensively to investigate electron gyro-scale fluctuations with varying electron temperature gradient scale length. Results from n = 3 braking studies are consistent with the flow shear dependence of ion transport. New results from electron Bernstein wave emission measurements from plasmas with lithium wall coating applied indicate transmission efficiencies near 70% in H-mode as a result of reduced collisionality. Improved coupling of high harmonic fast-waves has been achieved by reducing the edge density relative to the critical density for surface wave coupling. In order to achieve high bootstrap current fraction, future ST designs envision running at very high elongation. Plasmas have been maintained on NSTX at very low internal inductance l i ∼ 0.4 with strong shaping (κ ∼ 2.7, δ ∼ 0.8) with β N approaching the with-wall β-limit for several energy confinement times. By operating at lower collisionality in this regime, NSTX has achieved record non-inductive current drive fraction f NI ∼ 71%. Instabilities driven by super-Alfvénic ions will be an important issue for all burning plasmas, including ITER. Fast ions from NBI on NSTX are super-Alfvénic. Linear toroidal Alfvén eigenmode thresholds and appreciable fast ion loss during multi-mode bursts are measured and these results are compared with theory. The impact of n > 1 error fields on stability is an important result for ITER. Resistive wall mode/resonant field amplification feedback combined with n = 3 error field control was used on NSTX to maintain plasma rotation with β above the no-wall limit. Other highlights are results of lithium coating experiments, momentum confinement studies, scrape-off layer width scaling, demonstration of divertor heat load mitigation in strongly shaped plasmas and coupling of coaxial helicity injection plasmas to ohmic heating ramp-up. These results advance the ST towards next step fusion energy devices such as NHTX and ST-CTF.