No abstract

On March 15th 2007 a paroxysmal explosion occurred at the Stromboli volcano. This event generated a large amount of products, mostly lithic blocks, some of which impacted the ground as far as down to 200 m a.s.l., about 1.5 km far away from the active vents.Two days after the explosion, a new vapour emission was discovered on the north-eastern flank of the volcanic edifice, at 560 m a.s.l., just above the area called "Nel Cannestra". This new vapour emission was due to a block impact. In order to investigate the block impact area to understand the appearance of the vapour emission, we conducted on May 2008 a multidisciplinary study involving Electrical Resistivity Tomography (ERT), Ground Penetrating Radar (GPR), Self-Potential (SP), CO(2) soil diffuse degassing and soil temperature surveys. This complementary data set revealed the presence of an anomalous conductive body, probably related to a shallow hydrothermal level, at about 10-15 m depth, more or less parallel to the topography. It is the first time that such a hydrothermal fluid flow, with a temperature close to the water boiling point (76 degrees C) has been evidenced at Stromboli at this low elevation on the flank of the edifice. The ERT results suggest a possible link between (1) the main central hydrothermal system of Stromboli, located just above the plumbing system feeding the active vents, with a maximum of subsurface soil temperature close to 90 degrees C and limited by the NeoStromboli summit crater boundary and (2) the investigated area of Nel Cannestra, at similar to 500 m a.s.l., a buried eruptive fissure active 9 ka ago. In parallel, SP and CO(2) soil diffuse degassing measurements suggest in this sector at slightly lower elevation from the block impact crater a magmatic and hydrothermal fluid rising system along the N41 degrees regional fault. A complementary ERT profile, on May 2009, carried out from the NeoStromboli crater boundary down to the block impact crater displayed a flank fluid flow apparently connected to a deeper system. The concept of shallow hydrothermal level have been compared to similar ERT results recently obtained on Mount Etna and La Fossa cone of Vulcano. This information needs to be taken into account in general fluid flow models on volcanoes. In particular, peripheral thermal waters (as those bordering the northeastern coast of Stromboli) could be contaminated by hydrothermal and magmatic fluids coming from regional faults but also from the summit. (C) 2010 Elsevier B.V. All rights reserved

On 2 June 2006 the wastewater produced during the oil and gas field exploitation in High Agri Valley (southern Italy) started to be managed by disposal through pumping the fluids back into the subsurface at the Costa Molina 2 (CM2) injection well, located in the southeastern sector of the valley. The onset of microearthquakes (Ml ≤ 2) after 4 days at about 1.3 km SW of CM2 well suggests fluid injection induced seismicity by the diffusion of pore pressure. Moreover, the space-time evolution of 196 high-resolution relocated events reveals a previously unmapped NE dipping fault. We investigate the physical processes related to the fluid injection induced seismicity and delineate the previously unmapped fault by jointly analyzing seismicity data, geological observations, fluid injection data, the stratigraphic log of the CM2 well, and the electrical resistivity tomography survey carried out in the study area.

[1] The Southern Apennines range of Italy presents significant challenges for active fault detection due to the complex structural setting inherited from previous contractional tectonics, coupled to very recent (Middle Pleistocene) onset and slow slip rates of active normal faults. As shown by the Irpinia Fault, source of a M6.9 earthquake in 1980, major faults might have small cumulative deformation and subtle geomorphic expression. A multidisciplinary study including morphological-tectonic, paleoseismological, and geophysical investigations has been carried out across the extensional Monte Aquila Fault, a poorly known structure that, similarly to the Irpinia Fault, runs across a ridge and is weakly expressed at the surface by small scarps/warps. The joint application of shallow reflection profiling, seismic and electrical resistivity tomography, and physical logging of cored sediments has proved crucial for proper fault detection because performance of each technique was markedly different and very dependent on local geologic conditions. Geophysical data clearly (1) image a fault zone beneath suspected warps, (2) constrain the cumulative vertical slip to only 25-30 m, (3) delineate colluvial packages suggesting coseismic surface faulting episodes. Paleoseismological investigations document at least three deformation events during the very Late Pleistocene (<20 ka) and Holocene. The clue to surface-rupturing episodes, together with the fault dimension inferred by geological mapping and microseismicity distribution, suggest a seismogenic potential of M6.3. Our study provides the second documentation of a major active fault in southern Italy that, as the Irpinia Fault, does not bound a large intermontane basin, but it is nested within the mountain range, weakly modifying the landscape. This demonstrates that standard geomorphological approaches are insufficient to define a proper framework of active faults in this region. More in general, our applications have wide methodological implications for shallow imaging in complex terrains because they clearly illustrate the benefits of combining electrical resistivity and seismic techniques. The proposed multidisciplinary methodology can be effective in regions characterized by young and/or slow slipping active faults.Citation: Improta, L., et al. (2010), Detecting young, slow-slipping active faults by geologic and multidisciplinary highresolution geophysical investigations: A case study from the Apennine seismic belt, Italy,