No abstract

No abstract

Abstract. This paper proposes a new method to determine the reduction factor for producing a head garment with specified targeted pressure output. Pressure garment fabric mostly supplied to the local hospitals with no information of the material properties and the fabrication method generally used a single reduction factor at various body segments. Reduction factor defined as the percentage of reducing the garment size from the original circumference of the body part which contributes to the compression. The objective of this study is to compare the fabrication method of head garment using reduction factor equation from previous research with the new proposed method. The equation to predict the reduction factor requires the parameter of the fabric tension which is obtained from tensile test and radius of curvature of the human body parts. In the new proposed method, a 3D scanning was used for data acquisition to obtain the geometry of the head area. The pressure outputs are measured by a pressure measurement system developed from Flexiforce sensor and Arduino circuit board. By using the equation, the result shows the calculated reduction factor produced an extremely tight head garment compared to the conducted experiments which manage to produce an adequate reduction factor with a targeted pressure output of 20mmHg. The result of the experiment indicates that the reduction factor ranging from 17% to 23% compared to the equation which produces 20% to 47% of reduction factor. As an additional, the proposed experimental method can be used for different type of pressure garment fabrics in order to obtain the relationship between the reduction factor and the circumference of the body parts.

No abstract

No abstract

Modular furniture joint defined as a connection used to connect two or more wood pieces to produce furniture with multiple functions. Notofusy furniture joint made from plywood was less expensive. However, during the manufacturing process, it was occasionally caused tear-out of wood fibre. Therefore, this research has been carried out to investigate and compare the existing material and Fused Deposition Modelling (FDM) fabrication method on the designed modular furniture joint. Finite Element Analysis (FEA) of elasto-plastic method from ABAQUS CAE software and three-point bending test were used to evaluate the structural analysis of designed modular furniture joint. In this research, the final concept selected was able to withstand load up to 730 kg and it only weights 113.59 g. The long-term goal for this research was to evaluate the possibility of producing end products using FDM technology. It was found that FDM contributed to cost effective in low volume production. In this research, the material focused were Acrylonitrile Butadiene Styrene (ABS) and Polyethylene Terephthalate (PETG). However, future studies can be conducted to evaluate the possibility of using other 3D printing materials.

Pressure garment is a standard non-surgical treatment for hypertrophic scar caused by burn injury. However, the main problem identified was the non-uniform pressure distribution due to the complexity of the contour at the facial area. Therefore, padding was developed to produce more efficient pressure distribution. This study used 3D scanning apparatus to obtain the cross sections of the facial area. The padding was developed using 3D modeling software which act as an insert to fill the gaps at the contact area of the garment and facial areas. The result shows that by inserting the padding underneath the garment, the pressure outputs indicate an acceptable pressure range with the suitable reduction factor for the head garment fabrication.

Abstract. Facial deformities can impose burden to the patient. There are many solutions for facial deformities such as plastic surgery and facial prosthetics. However, current fabrication method of facial prosthetics is high-cost and time consuming. This study aimed to identify a new method to construct a customized facial prosthetic. A 3D scanner, computer software and 3D printer were used in this study. Results showed that the new developed method can be used to produce a customized facial prosthetics. The advantages of the developed method over the conventional process are low cost, reduce waste of material and pollution in order to meet the green concept.