The Panasqueira W-Sn deposit is the largest quartz-vein type deposit of the Iberian Peninsula and the most important wolframite deposit in Western Europe. The ore-veins are almost exclusively sub-horizontal. Besides ore-bearing sub-horizontal veins, the Panasqueira mine also contains barren quartz veins. There are essentially two generations of barren quartz: quartz, contemporaneous with the earliest regional metamorphism (QI), and recrystallized quartz, contemporaneous with the thermal metamorphism related to the granite intrusion (QII). Fluid inclusion studies (microthermometry and Raman) were undertaken in order to distinguish fluids contemporaneous with the barren quartz from those contemporaneous with the ore-bearing quartz (QIII). Fluid inclusion data indicate that the barren and ore-bearing quartz fluids are dominantly aqueous (93 to 98 mol% H20), with a nearly constant bulk salinity (8 to 12 wt% eq. NaC1), with the quantity of volatile component (determined by Raman spectrometry) higher in QIII, but never greater than 5 tool%. However, the CO2/CH4 + N2 ratio is different for each type of quartz. Volatiles are dominated by CH4 (10 to 96 tool% ZCH~) and/or N 2 (3 to 87 mol% ZN2) in the barren quartz and by CO2 (60 to 73 mol% ZCO2) in ore-bearing quartz. The bulk chemical composition of the fluids in QIII is comparable to that found commonly in hydrothermal fluids associated with wolframite mineralization, where Na > K > Ca and HCO3 > CI> SO,. A dispersion in TH (226 to 350 ~ found in QIII, together with a variation in the degree of filling (0.5 to 0.7) and with the consequent variation of fluid densities (0.70 to 0.79), may result from changes in the fluid pressure regime below lithostatic pressure, suggesting vein filling related to tectonic events.The well-known Panasqueira tungsten deposit, located in the Beira Baixa Province of Central Portugal, is the largest quartz-vein type deposit of the Iberian Peninsula and the most important wolframite deposit in Western Europe. Tin and copper are byproducts. The Panasqueira ore deposit consists of a dense swarm of sub-horizontal quartz-veins which host the wolframite mineralization. However, vertical and sub-horizontal barren quartzveins are also scattered throughout the district.A fluid inclusion study was undertaken in order to allow an easy and rapid distinction between barren and ore-bearing fluids, and consequently between barren and mineralized veins.
Regional geologyThe Panasqueira tungsten-tin deposit is located in the Central Iberian Zone of the Iberian Massif (Fig. 1). Country rocks underlying the Panasqueira district consist of a belt of folded sedimentary rocks, regionally metamorphosed to lower greenschist-grade (chloritesericite) during the Hercynian orogeny. This belt is composed of two distinct sedimentary series (Thadeu 1951(Thadeu , 1977(Thadeu , 1979:1. A several thousand-metre-thick lower marine flyschoid series of schist and greywacke, referred to as Beira Schist Formation (Schist-greywacke complex), widely distributed in North and Central P...
The Carris orebody consists of two partially exploited W-Mo-Sn quartz veins formed during successive shear stages and multipulse fluid fillings. They cut the Variscan post-D3 Gerês Itype granite. The most important ore minerals are wolframite, scheelite, molybdenite and cassiterite. There are two generations of wolframite. The earlier generation of wolframite is rare and has the highest WO 4 Mn content (91 mol%) and the most common wolframite contains 26-57 mol% WO 4 Mn. Re-Os dating of molybdenite from the ore quartz veins and surrounding granite yield ages of 279 ±1.2 Ma and 280.3±1.2 Ma, respectively which are in very good agreement with the previous ID-TIMS U-Pb zircon age for the Carris granite (280±5 Ma). The fluid inclusion studies on quartz intergrown with wolframite and scheelite, beryl and fluorite reveal that two distinct fluid types were involved in the genesis of this deposit. The first was a low to medium salinity aqueous carbonic fluid (CO 2 between 4-14 mol%) with less than 1.95 mol% N 2 , which was only found in quartz associated with wolframite. The other was a low salinity aqueous fluid found in all the four minerals. The homogenization temperatures indicate minimum entrapment temperatures of 226-310ºC (average 280ºC) for the H 2 O-CO 2 -N 2 -NaCl fluid and averages temperatures of 266ºC for scheelite and 242ºC, 190ºC and 160ºC for the last generations of beryl, fluorite and quartz, respectively. It was estimated that wolframite was deposited ~7 km depth, assuming a lithostatic pressure, probably due to strong pressure fluctuation caused by seismic events triggered by brittle tectonics during the exhumation event.
A C C E P T E D M A N U S C R I P T ACCEPTED MANUSCRIPTPrecipitation of scheelite and sulphides took place later, at the same depth, but under an hydrostatic or suprahydrostatic pressure regime, and probably caused by mixing between the magmatic-hydrothermal fluid and meteoric waters that deeply penetrated the basement during post-Variscan decompression.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.